NPM Calibration Manual-En.pdf - 第50页
NPM Maint en anc e E di ti on 9.8 Li ne Camer a EJM9BE-M B-09M-21 Page 9-49 9.8 Line C amera Thi s procedur e i s co mm on to 12-noz zle, 8-nozzl e, and 2-noz zl e heads. If the tar get table is provi ded wit h feeder s,…
NPM
Maintenance Edition
9.7 Placement Load
Page 9-48 EJM9BE-MB-09M-21
6. Setting the decimal point position
1
Set a screen display to ‘dP.’
2
Press to blink ‘00.000.’
3
Press to set a decimal point
(a) at the position ‘00.000.’
4
Press to accept.
5
Hold down for one second or
more.
•
The operation level returns.
EJM4A-424E
EJM4A-415E
EJM4A-147E
a
EJM4A-147E
NPM
Maintenance Edition
9.8 Line Camera
EJM9BE-MB-09M-21 Page 9-49
9.8 Line Camera
This procedure is common to 12-nozzle, 8-nozzle, and 2-nozzle heads.
If the target table is provided with feeders, remove them beforehand.
1
Press .
2
Press [L-camera].
3
Select a table.
∗
Select the target table for calibration.
4
Press + [H
θ
axis origin].
UnitCalibLineCamera-01E00
1
2
UnitCalibLineCamera-01E00
3
4
NPM
Maintenance Edition
9.8 Line Camera
Page 9-50 EJM9BE-MB-09M-21
5
Press + [OK].
•
The head moves to the working position.
6
Turn OFF the servo switch.
7
Open the safety cover.
8
Attach the line camera jig.
Line camera jig
For 12-/8-nozzle head
For 2-nozzle head
12-nozzle head
∗
Attach the line camera jig to the nozzle
position 9.
8-nozzle head
∗
Attach the line camera jig to the nozzle
position 6.
2-nozzle head
∗
Attach the line camera jig to the nozzle
position 1.
9
Close the safety cover.
UnitCalibLineCamera-02E00
5