M6_ServiceManual_e.pdf - 第51页
3 Mechanical Section 3-21 Grease nipple Grease nipple X-axis Ball Screw and Linear guide Lubrication using a grease gun Linear g uide X-axis ball scre w Grease nipple Linear guide Grease-gun nozzle (NZ3 ） Wipe off old gr…
3 Mechanical Section
3-20
Lubrication
Lubrication
Lubricate the specified portions listed below with cotton swab soaked with lubricant.
UNIT PORTION LUBRICANT FREQ.
Ball Screw of X-axis Grease Every two weeks
Linear Guide of X-axis (Upper and Lower) Grease Every two weeks
Ball Screw of Y-axis (Right and Left) Grease Every two weeks
Linear Guide of Y-axis (Right and Left) Grease Every two weeks
Feeder Bank Plates Grease Every two weeks
M6 Conveyor Width Adjusting Screw Grease Monthly
Conveyor Guide Shaft Grease Monthly
Ball Screw of Z-axis Grease Every two weeks
Guide of Z-axis Grease Every two weeks
Spline shaft of R-axis Grease Every two weeks
Linear Guide of S-axis Grease Every two weeks
Nozzle ) Refer to 3-8. Silicone Grease Weekly
Nozzle Holder Roller ) Refer to 3-11. Silicone Grease Monthly
MX-20 Ball Screw Grease Monthly
(OPTION) Slide Pack Grease Monthly
Slide Pack (Shuttle Unit) Grease Monthly
MXR-20 Ball Screw Grease Monthly
(OPTION) Linear Shaft Grease Monthly
MX-ST2 Shaft Grease Monthly
(OPTION) Parallel Pin Grease Monthly
Downside of cap Grease Monthly
Contact part of shaft and cap Grease Monthly
Contact part of shaft and bracket Grease Monthly
NOTE: Do not apply excessive oil/grease. This may cause oil/grease scattering when the mounter is in operation.
3 Mechanical Section
3-21
Grease nipple
Grease nipple
X-axis Ball Screw and Linear guide
Lubrication using a grease gun
Linear
g
uide
X-axis ball screw
Grease nipple
Linear guide
Grease-gun nozzle (NZ3）
Wipe off old grease.
Linear guide
Ball screw
Grease-gun nozzle (H-shape)
3 Mechanical Section
3-22
Y-axis Ball Screw
The following pictures are left side Y-axis ball screw when viewed from the rear side. There are two Y-axis
ball screws at the right and the left.
Lubrication using a grease gun
Lubricate both the right and the left Y-axis ball screws as shown below.
Y ball screw
Wipe off old grease from the
ball-screw end.
Y-axis slider
Grease nipple
Y-axis ball screw
Y-axis slider
Grease gun （NZ3）