M6_ServiceManual_e.pdf - 第77页

4 Electrical Section 4-17 Control Board Handling Control Board Note the followings when handl ing PC boards.  Do not touch control boards by wet hands.  Do not handle control boards where there are m etal chips around.…

4 Electrical Section

4-16

■ Device 12

Address Bit No. Signal Name Address Bit No. Signal Name

0000h 0 Device No. Bit0 0003h 0

MXR Pallet Bar Open1 / MX20 Pallet

Interlock in Stocker

1 Device No. Bit1 1

MXR Pallet Bar Open2 / MX20 Pallet

Stopper Off in Stocker

2 Device No. Bit2 2

MXR Pallet Bar Close1 / MX20 Pallet

Clamp Off on Shuttle

3 Device Added Information Bit0 3

MXR Pallet Detect in Stocker / MX20

Pallet Detect in Stocker

4 Device Added Information Bit1 4

MXR Hook Unlock / MX20 Relay Hook

Down

5 Device Added Information Bit2 5 W-MXR SETUP Switch

6 Device Added Information Bit3 6 MXR Cover Open / MX20 Cover Open

7 Output Register Value Bit0 7 W-MXR RELAY ON

0001h 0 Output Register Value Bit1 0004h 0 W-MXR SERVO Switch

1 Output Register Value Bit2 1 W-MXR EMG

2 Output Register Value Bit3 2 IN1

3 Output Register Value Bit4 3 IN2

4 Input Register Value Bit0 4 IN3

5 Input Register Value Bit1 5 IN4

6 Input Register Value Bit2 6 IN5

7 Input Register Value Bit3 7 IN6

0002h 0

2 MXR Pallet I/L

4 MXR Pallet Bar Close2

5 MXR Stocker I/L / MX20 Stocker I/L

MXR Hook Lock / MX20 Relay Hook Retract

End

MXR Pallet Detect on Hook / MX20 Pallet

Detect on Shuttle

4 Electrical Section

4-17

Control Board

Handling Control Board

Note the followings when handling PC boards.

 Do not touch control boards by wet hands.

 Do not handle control boards where there are metal chips around.

 To handle control boards in the control rack, never touch the connecting portion where gold is plated. If

the connecting portion is covered with dust, the machine doesn't work properly. Clean with alcohol.

Gold Plating

4 Electrical Section

4-18

Electrodes on Feeder / Feeder Bank

When electrodes on the feeder bank and the tape feeder get dirty, clean them as follows:

NOTE: If the electrodes are touched by hand or have come into contact with foreign matter, cleaning is

recommended even if no dirt can be observed visually.

ACTION: Clean the electrodes by wiping off dust gently with a dry cotton swab or non-woven fabric. When cleaning

them, check that the pins are not bent. If they are bent excessively, contact i-PULSE for repair. Continuing

to use them if the pins are bent may scratch the contact surface of the feeder bank.

Do not use alcohol, water base detergents and organic solvent, such as

thinner, benzene and acetone.

Do not use sandpaper and tools with sharp blade or edge, such as a knife and

a screwdriver.

NOTE: If they get stubborn stains, try not to get rid of them forcedly. Please contact us.

Cotton swab

Pin Electrodes on feederElectrodes on feeder bank

Cotton swab