00900068-02_SM_ASM_ProcessLens_EN.pdf - 第41页

ASM Proces sLens Single - l ane 03/2020 Edit ion 41 Ke y: 1) Sc re w ( 4 x) 2) Gear 3) Conve yor m otor b elt Figure 3- 43 : Conveyo r motor (f rom back) 2. Unscrew the screws ( 4 x) using a n Allen Ke y size 4. 0. 3. Ta…

100%1 / 92
ASM ProcessLens Single-lane 03/2020 Edition
40
3.14 Changing the conveyor motor
Requirement:
● Machine is switched off.
Figure 3-41: Overview of the conveyor motor
Key:
1) Conveyor motor
belt
2) Conveyor motor
3) Width adjustment
belt
4) Width adjustment
motor
Key:
1) Connectors for the conveyor
motor
2) TSP400
Figure 3-42: TSP400
1. Disconnect the connectors from the TSP400.
ASM ProcessLens Single-lane 03/2020 Edition
41
Key:
1) Screw (4 x)
2) Gear
3) Conveyor motor belt
Figure 3-43: Conveyor motor (from back)
2. Unscrew the screws (4 x) using an Allen Key size 4.0.
3. Take off the conveyor motor belt.
4. Take out the motor of the machine
Key:
1) Conveyor motor
2) Gear
3) Screw
Figure 3-44: Conveyor motor
5. Unscrew the screw off the gear of the old motor and replace it onto the new motor using an
Allen Key size 4.0.
6. Put the motor back in place.
7. Put the belt on and tighten the screws.
8. Connect the connectors to the TSP400.
Installation
Follow the removal instructions in reverse order for installation.
ASM ProcessLens Single-lane 03/2020 Edition
42
3.14.1 Check the function of the conveyor motor
Requirements:
● Machine is switched on.
● Circuit board is placed at the beginning of the machine.
Figure 3-45: Diagnostic page
1. Go to the diagnostic page.
2. Click on the tab "Unit function".
3. Go to the section "Conveyor".
4. Click the button "PCB In" and the button "PCB Out".
5. If the circuit board cannot move through the machine the conveyor system needs to be
adjusted.
3.15 Changing the width adjustment belt
Requirements:
● Machine is switched off.
● Tension meter.
Key:
1) Tension ring
2) Screw A
3) Screw B (2 x)
4) Belt
5) Motor
Figure 3-46; Motor for the width adjustment