00900068-02_SM_ASM_ProcessLens_EN.pdf - 第48页

ASM Proces sLens Single - l ane 03/2020 Edit ion 48 3.17 Chan ging the motor of the lifti ng table Require ment: ● Machine is switche d off . Ke y: 1) Screw (4 x) 2) Motor of the lif ting tabl e plat e 3) Liftin g table …

100%1 / 92
ASM ProcessLens Single-lane 03/2020 Edition
47
Installation
Follow the removal instructions in reverse order for installation.
3.16.1 Check system test
Requirement:
● Machine is switched on.
Figure 3-53: Diagnostic page
1. Open the Diagnostic page.
2. Go to the tab "System Test"
3. Click on the button "Track zero point calibration"
4. A message will indicate that the calibration was successful.
5. Go to the tab Unit function.
6. Proceed to the conveyer section and press the buttons "Track Home".
7. On screen messages will confirm the successful function test.
8. If the conveyor system does not move or any fault message occurs, the conveyor system
needs to be adjusted.
ASM ProcessLens Single-lane 03/2020 Edition
48
3.17 Changing the motor of the lifting table
Requirement:
● Machine is switched off.
Key:
1) Screw (4 x)
2) Motor of the lifting table plate
3) Lifting table plate
Figure 3-54: Lifting plate
1. Unscrew the screws (1) off the lifting table plate (3) using an Allen key size 5.0.
2. Remove the lifting table plate (3).
3. Disconnect all connectors from the TSP400.
Key:
1) Screw (3 x)
Figure 3-55: Lifting table motor
4. Unscrew the screws (1) off the lifting table motor using an Allen key size 5.0.
ASM ProcessLens Single-lane 03/2020 Edition
49
Key:
1) Stopper screw
2) Cam
3) Screw A
Figure 3-56: Lifting table motor
5. Unscrew screw A (3) from the cam using an Allen key size 5.0
6. Remove the motor.
3.17.1 Replace the motor of the lifting table
Requirements:
● Machine is switched off.
● The motor of the lifting table is dismantled.
● The lifting table plate is dismantled.
1. Position the lifting table motor.
2. Connect the connectors at the TSP400.
Key:
1) Stopper screw
2) Cam
3) Screw A
Figure 3-57: Lifting table motor
3. Put the cam (2) in the right position so that the cam hits the stopper screw (1). Fasten the
screw of the cam using an Allen key size 5.0.
NOTICE
Positioning of the cam