1OM-1603-006_w.pdf - 第126页
1OM-1603 3-1 1. Automatic Operation : Chap.3 1 108-005 1. Automatic Operation Shown below is the ow of the automatic operation. 1.1.1 Confirmation of Power Supply 1.1.2 Confirmation of Air Pressure 1.1.3 Confirmation of…
1OM-1603
0908-002 3-B
1OM-1603
3-1
1. Automatic Operation : Chap.3
1108-005
1. Automatic Operation
Shown below is the ow of the automatic operation.
1.1.1 Confirmation of Power Supply
1.1.2 Confirmation of Air Pressure
1.1.3 Confirmation of Cover Section
1.1.4 Safety Confirmation of Machine Surroundings
1.2.1 Power ON
1.2.2 Preparation for Components
1.2.3 Preparation for PCBs
1.3.1 Starting the system program
1.3.2 Login Operation
1.3.3 "Product" Window
2. Pattern Program Change
3. Component Replenishment
4. PCB Replenishment
5.1 Stop of Machine Operation
5.2 Interruption of Automatic Operation
5.5.1 Stop of Automatic Operation
5.5.2 Logout
Inspections before
Automatic Operation
Preparation before
Automatic Operation
Start of Automatic
Operation
Replenishment of
Components and PCBs
Stop, Interruption, and
Restart of Automatic
Operation
End of Automatic Operation
Program Change Operation
Flow of Automatic Operation F1C1
1OM-1603
3-2
1. Automatic Operation : Chap.3
1108-005
1.1 Inspections before Automatic Operation
1.1.1 ConrmationofPowerSupply
Conrm that the main breaker of the power supplied to the machine is turned
"ON".
•
Power Supply : 200 ± 20 V AC, 3-Phase
•
Apparent Power : Approx. 7.4 kVA
1.1.2 ConrmationofAirPressure
Conrm that the air pressure is set to the following.
•
Main Pressure : 0.45 MPa (4.6 kgf/cm
2
)
Note
The above represents the pressure specied while the machine is in the
"STOP" mode.
Min. 0.4 MPa (4.1 kgf/cm
2
) is required while the machine is running.
•
Air Blowing Pressure : 0.05 MPa (0.5 kgf/cm
2
)
Main Pressure
0.45 MPa (4.6 kgf/cm
2
)
Air Blowing Pressure
0.05 MPa (0.5 kgf/cm
2
)
F1C2
Notice
(a) Do not change the setting of the air pressure. Otherwise, the
pneumatic devices will not work normally.
(b) Be sure to use dry and clean air. If moisture, oil, dust, etc., enter
a pneumatic device (air cylinder, etc., used in this machine), it will
result in a breakdown of the machine.