OM-1683-001_w.pdf - 第31页

14 OM-1683 7.1 ConrmationofPCBT ransferandPositioning The following describes how to check the status of the PCB transfer and positioning in the "PCB XFER" window (a menu of "AUTO OPN"). Proced…

OM-1683

7. "PCB XFER" Window

This window enables the operator to move the PCB on each block on each

lane on the conveyor to the next block.

Reference

Refer to "6. "PCB XFER" Window" in Chapter 6, Volume 2, in the

SIGMA-G5 main machine instruction manual for the information other

than for dual transfer.

[1]

[2] [2]

Fig. 14 PCB XFER

[1] Conveyor Image Display Pane

Each block in the graphic image of the conveyor is provided with a button

function.

When the [START] button on the operation panel is pressed in 10 seconds

after a conveyor block button, the PCB is transferred to the block position.

[2] PCB LOCA

TE (PCB LOCATE AL, AR, BL, BR)

Using these buttons, the PCB positioning is performed for each lane and

each block.

When the [START] button on the operation panel is pressed in 10 seconds

after the [Execute] button, the backup base of the selected stage moves up

and the PCB is positioned.

When the [START] button on the operation panel is pressed in 10 seconds

after the [Release] button, the backup base moves down and the PCB

positioning is released.

Graphic

Development

1103-001

7. "PCB XFER" Window

OM-1683

7.1 ConrmationofPCBTransferandPositioning

The following describes how to check the status of the PCB transfer and

positioning in the "PCB XFER" window (a menu of "AUTO OPN").

Procedure

(1) Display the "PCB XFER" window using the following icon procedure.

Fig. 15

(2) Send the PCB in the lane where the PCB transfer and positioning status are

conrmed with the input machine.

(3)

Select a desired block button (expressed graphically) for "PCB LOCATE 1".

In 10 seconds, press the [START] button on the operation panel to transfer

the PCB.

(4)

Conrm that the PCB can be transferred normally and move smoothly

without falling down during the transfer.

(5)

Press the [Execute] button (entitled "PCB LOCATE L").

In 10 seconds, press the [START] button on the operation panel.

(The backup base moves up. )

(6)

Press the cover lock switch to turn off the lamp.

(The transparent cover is unlocked. )

1103-001

7.1ConrmationofPCBTransferandPositioning

OM-1683

(7) Open the transparent cover.

CAUTION

The load power to the motors, etc., is turned OFF

but the setup operation must be performed carefully

when you put your hand inside the machine. Avoid

handandngerinjuries.

(8) Slightly push the PCB by nger to conrm that there is no problem in the

location of the support pins.

(

9) Close the transparent cover.

(10) Press the cover lock switch to turn on the lamp.

1103-001

7.1ConrmationofPCBTransferandPositioning