OM-1683-001_w.pdf - 第37页
20 OM-1683 1 1.1 "Conveyor" T ab Sheet This window enables the operator to adjust the overall setup or manual setup for the conveyor width in each lane. Reference Refer to "4.3.1 "CONVEYOR" W ind…
19
OM-1683
11. "CONVEYOR" Window
This button is used for the adjustment operation for the conveyor width overall
setup.
[1]
Fig. 19 CONVEYOR
[1] Tabs
The "CONVEYOR" Window is provided with the following two tabs.
When cach tab is pressed, the corresponding tab sheet appears.
Table 1
Tabs Description
Conveyor
When this tab is selected the tab sheet for the conveyor operation is displayed.
PCB Stpr.
When this tab is selected the tab sheet for the PCB stopper operation is
displayed.
1103-001
11. CONVEYOR
Graphic
Development
20
OM-1683
11.1 "Conveyor" Tab Sheet
This window enables the operator to adjust the overall setup or manual setup
for the conveyor width in each lane.
Reference
Refer to "4.3.1 "CONVEYOR" Window" in Chapter 1, Volume 3, in the
SIGMA-G5 main machine instruction manual for the information other
than for dual transfer.
[1]
Fig. 20 Conveyor
[1] Conveyor selection Button
Using these buttons, the target position movement, reference position
adjustment or conveyor section (Conveyor L, Conveyor A, Conveyor B or
Conveyor R) is selected.
1103-001
11.1 "Conveyor" Tab Sheet
Graphic
Development
21
OM-1683
11.2 "PCB Stpr." Tab Sheet
This tab sheet enables the operator to adjust the PCB stopper for each lane
and each block.
Reference
Refer to "4.3.2 "PCB Stpr" Window" in Chapter 1, Volume 3, in the
SIGMA-G5 main machine instruction manual for the information other
than for dual transfer.
[1]
Fig. 21 PCB Stpr.
[1] Block selection Button
Using these buttons, the block in the lane where there is the PCB stopper to
be operated, is selected.
1103-001
11.2 "PCB Stpr." Tab Sheet
Graphic
Development