TM6419.PickupMACS.pdf - 第27页

   SMT Software Engineering Group IM Operations Y AMAHA MOT OR CO., L TD.  MDOC-SOFT50177 27/28  Input datab ase numbers according to nozzle group s, by referring to the following table. Nozzle T ype Data base No. …

100%1 / 28
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
26/28
(7) Dialog showing the data registration completed. Press the [OK] button.
(8) Check that parts data exists on [Part database overview]. Repeat (3) to (7) to register all
nozzles into the database.
(9) Next, reflect the registered parts database to the setting of Nozzle MACS. Press the
[Machine] button to open the machine setup dialog.
(10) Select [Machine] - [Setting] - [Machine Data] - [Precision] - [Pickup MACS]. Select
“Nozzle MACS” from the combo box.
(11) Input the registered database number into [Database No.]. Do this for all the nozzles.
*4
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
27/28
Input database numbers according to nozzle groups, by referring to the following table.
Nozzle
Type
Database
No.
Nozzle
Type
Database
No.
Nozzle
Type
Database
No.
Nozzle
Type
Database
No.
TYPE-301 962 TYPE-311
960(*)
TYPE-501 962 TYPE-511 960
TYPE-302 965 TYPE-312
961
TYPE-502 965 TYPE-512 961
TYPE-303 966 TYPE-313
972
TYPE-503 966 TYPE-513 972
TYPE-304 967 TYPE-314
966
TYPE-504 967 TYPE-514 966
TYPE-305 968 TYPE-315
967
TYPE-515 967
TYPE-306 969 TYPE-316
968
TYPE-506 969
TYPE-307 970 TYPE-317
969
TYPE-507 970 TYPE-517 969
TYPE-318
970
TYPE-518 970
* If “311Type- 1Hole” is used, setting of [TYPE-311] is registered “964”.
(12) Save and read the board data again.
How to setting of Feeder MACS mark data and setting of Nozzle MACS mark data is end.
6.3. Using with Pick Position Correct
This function is recommended with [Pick Position Correct] function. It is more effective to use
these functions together.
Recommended settings to use [Pick Position Correct] function are as follows.
(1) Open the [VmSpec].
(2) Select [Pick Position Specification].
(3) Select [Use with Feeder Correction] on [Correct Mode].
(4) Input the each parameter of using nozzle type. Recommended parameters are as follows.
*4
*1
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
28/28
* In the figure above, a 0402 chip nozzle is set as [Sp. Nozzle A].
Check points of each parameter are as follows.
1. [Available] is [Use].
2. [Max Sample Num.] is [20].
3. [Ignore Limit X(um)] and [Ignore Limit Y(um)] are [0].