00193888-0402_AI_LBO_HFXD3_DE+EN.pdf - 第41页

Long board 2 Assembly instructions: Long board opt ion - SIPLACE HF-series / X-series / D3 02/2007 Edition 41 : Place the adjusting gauge in the conv eyor and push it against the stopper . The gauge must lie against th e…

100%1 / 54
2 Assembly instructions: Long board option - SIPLACE HF-series / X-series / D3 Long board
02/2007 Edition
40
: Fix the cables and air hoses so that they do not rub against any moving parts, such as width
adjustment unit, lifting table, etc.
2
: Close all open cable ducts in both processing areas.
: Attach the protective covers over the cable ducts in both processing areas.
: Attach the lifting table beds in both processing areas.
2
: Close all the safety devices.
: Switch the placement machine on at the main switch.
2
2
2.5.4 Adjusting the stopper units
: Set the conveyor width to 200 mm.
: Switch on the laser light barrier via the I/O functions in SITEST (see Section 2.7).
: Use the I/O functions to extend the stopper.
: Use the adjusting gauge to check the dimension 160 mm.
Fix cables and hoses
Long board 2 Assembly instructions: Long board option - SIPLACE HF-series / X-series / D3
02/2007 Edition
41
: Place the adjusting gauge in the conveyor and push it against the stopper.
The gauge must lie against the stopper and the stationary conveyor side wall.
2
2
: Check whether the laser beam can be seen on the entire front edge of the adjusting gauge. If
this is not the case, adjust the stopper so that the laser beam is visible.
To do this, loosen the fixing screws on the stopper, align the stopper and then tighten the
screws once more.
2
2
Adjusting
gauge
Stopper
Laser light barriers
Laser dots must be visible.
2 Assembly instructions: Long board option - SIPLACE HF-series / X-series / D3 Long board
02/2007 Edition
42
The adjusting gauge should therefore not lie inside the light barrier because it will interrupt the
beam on one side: 2
2
2
: Adjust all the stoppers on all the conveyor tracks.
2
The adjustment must be repeated whenever the stopper unit is dismantled and refitted. 2
2
2
2.6 Changes in the SITEST program
The option does not have to be selected in the SITEST program: it is detected automatically when
it is plugged into the conversion board. 2
2
The beam does not
fall along the adjust-
ing gauge.