00198001-01_IM_709.0_DE_EN.pdf - 第36页
Station Software 709.0 / Installation Manual Ausgabe 11/2015 E dition 36 6.1 Welcome S creen Figure 6-3: Welcome screen ► Click the Next button. The necessary f iles are installed on the Coplan comput er or feeder comput…
Station Software 709.0 / Installation Manual Ausgabe 11/2015 Edition
35
The following dialog box is opened:
Figure 6-2: Selecting computer / software
► Click the VISIONPC for COPLAN button to install the Coplan computer software.
Or:
► Click the VISIONPC for BulkFeeder X button to install the feeder computer software.
NOTICE
The Coplan computer and feeder computer software cannot be combined with each
other!
Installation of the Coplan computer or feeder computer software continues with the welcome
screen.
Station Software 709.0 / Installation Manual Ausgabe 11/2015 Edition
36
6.1 Welcome Screen
Figure 6-3: Welcome screen
► Click the Next button.
The necessary files are installed on the Coplan computer or feeder computer.
6.2 Finalizing the Installation
NOTICE
The status only lists the programs that have just been installed.
If errors occurred during installation, the status is indicated by the Error button being
displayed next to the program name instead of the Ok button.
► If you wish to read the log of the installation of any program, click the Ok (or Error) button next
to the name of the program. The Notepad is started and displays the appropriate file.
Station Software 709.0 / Installation Manual Ausgabe 11/2015 Edition
37
Figure 6-4: Finalizing the installation
► Click the Finish button.
► Follow the instructions in the Assembly Instructions for the 3D Coplanarity Module, item no.
[00197395-xx] if you have installed the Coplan computer software.
► Follow the instructions in the SIPLACE BulkFeeder X Operating Manual, item no.
[00198045-xx] if you have installed the feeder computer software.
CAUTION
► Wait a few seconds after you have clicked the Finish button, before you shut down
and switch off the computer / the machine!
As some installation steps are not performed until the end of the installation by the
InstallShield, the installation might otherwise be incomplete, what may cause
problems during further installations.
NOTICE
To establish the connection between the SIPLACE Coplan computer software or feeder
computer software and the SIPLACE station software after installation has been
completed, the Coplan computer or feeder computer and the machine computer must
first be shut down and the machine must then be switched off completely.
► To do this, open the Start menu and select All Programs – SIPLACE – Shutdown Vision_SR
(all).
► Switch the machine off when the computer systems have shut down.
► Switch the machine back on again. This then reboots the Coplan computer or feeder computer
and the machine computer.