YS12P_YS12F_Mainte_E.pdf - 第35页

xxxii Safety instructions n Label positions W arning/caution labels A TS15 (YS12F) ■ Door opening section ■ Open/close cover inner side ■ Open/close cover , Conveyor opening ■ Lower panels ■ Open/close cover inner side ■…

100%1 / 130
xxxi
Safety instructions
n
Label positions
Warning/caution labels
YS12F Rear side
■ Open/close cover inner side
■ Open/close cove,
Conveyor opening
■ Lower panels
■ Panel inner side
■ Side
■ Cutter section
■ Feeder setup section
■ Cutter inner side
93202-L7-20
Warning/caution labels
Controller
■ Top of controller
■ Controller front panel
93203-L6-20
xxxii
Safety instructions
n
Label positions
Warning/caution labels
ATS15 (YS12F)
■ Door opening section
■ Open/close cover inner side
■ Open/close cover,
Conveyor opening
■ Lower panels
■ Open/close cover inner side
■ Panel inner side
93203-L7-20
General Contents
Introduction
1. About this manual i
2. Maintenance list ii
Chapter 1 Maintenance
1. Maintaining machine performance 1-1
1.1 Essential conditions and working environment 1-1
1.2 Importance of periodic inspections and cleaning 1-2
2. Preparing for maintenance tasks 1-3
2.1 Consumable parts and replaceable parts (for repairs) 1-3
2.1.1 Consumable parts 1-3
2.1.2 Nozzles 1-5
2.1.3 Replaceable parts (for repairs) 1-7
2.2 Maintenance tools 1-8
2.2.1 Cleaning tools 1-8
2.2.2 Lubricating tools and grease 1-10
2.2.3 Special tool 1-12
2.3 Required tools 1-13
Chapter 2 Daily maintenance items
Before beginning work 2-1
1. Checking the nozzle 2-2
1.1 Check with software 2-2
1.1.1 Vacuum level when nozzle is open 2-4
1.2 Checking the nozzles visually 2-5
2. Cleaning the feeder plate 2-6
3. Cleaning Multi-view camera protective glass 2-7
Chapter 3 Periodic maintenance items
1. Weekly inspection 3-1
1.1 Inspecting and cleaning the nozzles 3-1
1.1.1 Inspecting and cleaning the slide section 3-1
1.1.2 Checking the nozzle leaf springs 3-3
1.1.3 Cleaning the nozzle tip 3-4
1.2 Cleaning and lubricating the gripper nozzle (option) 3-6
1.2.1 Inspecting the gripper nozzle 3-6
1.2.2 Cleaning and lubricating the gripper nozzle 3-6
1.3 Checking the conveyor sensor condition and operation 3-8
EMM717B200