00194398-01.pdf - 第70页

SIEMENS AG 2004 All rights reserved Technische Änderungen vorbehalten Artikel-Nr.: 00194398-01 Siemens Aktiengesellscha ft Bestellung an: SIEMENS L&A Electronics Assembly, Rupert-Mayer-Strasse 44 D-81359 Muenchen Pri…

Retrofit instructions SIPLACE HS-60

2.12 Error messages, possible causes 12/2004 Edition

2.12 Error messages, possible causes

The following error message is output in the event of an error: 2

– "Error in ceramic substrate centering 1" or

– "Error in ceramic substrate centering 2"

The placement sequence is stopped as a result. 2

The message indicates that the sensor signal for "opened" (1) / "closed" (0) is not present.

The option 1 means that the error has occurred in processing area 1 or 4 (see Fig. 2.1 - 1). 2

– The option 2 means that the error has occurred in processing area 2 or 3 (see Fig. 2.1 - 1).

Possible causes:

– Fault in compressed air line / leaking connection / solenoid valve cable badly, not or incorrectly

plugged into the solenoid valve / fault in solenoid valve.

– Wrong proximity switch response distance / tension spring detached from flat cylinder, proxim-

ity switch cable badly, not or incorrectly plugged into the X-axis centering unit / fault in proximity

switch.

– Plug-in connectors assigned incorrectly on the conversion board (X34/X35) or plug-in connec-

tors for conveyor 1 and 2 swapped over.

2.13 Preventive maintenance

: Clean and grease the ball race in the X axis centering unit.

: If necessary, check that the pneumatic drive runs smoothly.

Artikel-Nr.: 00194398-01 Siemens Aktiengesellschaft

Bestellung an:

SIEMENS L&A

Electronics Assembly,

Rupert-Mayer-Strasse 44

D-81359 Muenchen

Printed in the Federal Republic of Germany

Order no.: 00194398-01 Siemens Aktiengesellschaft

To be ordered from:

SIEMENS L&A

Electronics Assembly,

Rupert-Mayer-Strasse 44

D-81359 Muenchen

Printed in the Federal Republic of Germany