00198574-01_Process_Foundation_DEK_Micron_EN.pdf

Process Foundation DEK Micron-Series Edition 12/2017 EN

Process Foundation

DEK Micron-Series

Edition 12/2017 EN

All names identified by ® are registered trademarks of ASM Assembly Systems GmbH & Co. KG. The remaining

trademarks in this publication may be trademarks whose use by third parties for their own purposes could violate

the rights of the owner.

We have reviewed the contents of this publication to ensure consistency with the hardware and software de-

scribed. Since variance cannot be precluded entirely, we cannot guarantee full consistency. However, the informa-

tion in this publication is reviewed regularly and any necessary corrections are included in subsequent editions.

ASM Assembly Systems Weymouth Ltd

11 Albany Road, Granby Industrial Estate

Weymouth, Dorset

DT4 9TH, England

Item no.: 00198574-01

www.dek.com Printed by ASM Assembly Systems

1 Machine Safety

1.1 GENERAL

Process Foundation DEK Micron-Series 12/2017 3

1 Machine Safety

1.1 GENERAL

CAUTION

Any staff working on the machine must be familiar with the safety instructions in the

technical reference manual and observe these at all times. The following safety instructions

are only an excerpt from the chapter "Operational Safety" in the machine technical

reference manual. For further detailed safety information please refer to the manuals that

was supplied with your machine.

1.2 HAZARDOUS MATERIALS

Hazardous materials, as defined by NFPA 497 (National Fire Protection Association), are not

recommended by ASM for use on this machine. If one or more hazardous materials are used,

decontamination must be carried out in accordance with SEMI S12 or equivalent local regulations.

1.3 Warnings, Prohibitions, and Cautions

The warning, prohibition and caution notices below are fitted to the machine and shown in the

relevant procedures within this manual.

NOTICE

NOTE

Some of the warning symbols below may not be applicable to your machine.

Symbol Definition

PROHIBITION

MACHINE COVERS. IN ORDER TO PROTECT PERSONNEL AND TO PREVENT

DAMAGE TO THE MACHINE, COVERS ARE FITTED TO THE MACHINE FRAME.

THESE PANELS MUST ONLY BE REMOVED BY SUITABLY QUALIFIED

PERSONNEL.

WARNING

MOVING PARTS. MOVING PARTS ARE PRESENT IN THE VICINITY OF THIS

WARNING LABEL, THESE PARTS HAVE THE POTENTIAL TO CAUSE INJURY.

WARNING

BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN

THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE

FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.

WARNING

SOLVENT SPRAY. THE UNDERSTENCIL CLEANER SPRAYS A FINE JET OF

SOLVENT SOLUTION ON TO THE CLEANER. APPROVED PROTECTIVE

CLOTHING SHOULD BE WORN.

CAUTION

RECOMMENDED SOLVENTS. ANY SOLVENTS USED MUST COMPLY WITH

LOCAL ENVIRONMENTAL GUIDELINES. ASM RECOMMEND USING SOLVENTS

THAT ARE ENVIRONMENTALLY FRIENDLY, IE CFC FREE AND WATER BASED.

SOLVENTS USED MUST HAVE FAST EVAPORATION RATES AND FLASHPOINT

SPECIFICATIONS GREATER THAN 39°C.

CAUTION

SOLVENT SOLUTION. DO NOT MIX SOLVENT SOLUTIONS. FLUSH THE SOLVENT

TANK THOROUGHLY WHEN CHANGING TO A DIFFERENT SOLVENT SOLUTION.