Printer 710_810 v8 Adjustable Screen Mount.pdf - 第15页

ADJUSTA BLE SCREEN MOUN T (ASM) REPLACEMENT PROCEDURES Chapter Issue 7 Oct 06 Technical Reference Manual 12.15 6. Route the pneumati c supply pipe and electri cal cable to the rear web connectio ns. Fit the loom and pi p…

100%1 / 22
ADJUSTABLE SCREEN MOUNT (ASM)
REPLACEMENT PROCEDURES
12.14 Technical Reference Manual Chapter Issue 7 Oct 06
4. At the rear web assembly, tighten the two horizontal chase rail securing bolts
until the outer face of the chase rail just touches the web face.
CAUTION
SECURING BOLTS.
The two rear web horizontal chase rail securing bolts
must not be fully tighten at this juncture otherwise, damage to the
machine may occur.
5. Fully tighten the vertical chase rail securing bolt and subsequently complete
the tightening of the two horizontal rear chase rail securing bolts.
ADJUSTABLE SCREEN MOUNT (ASM)
REPLACEMENT PROCEDURES
Chapter Issue 7 Oct 06 Technical Reference Manual 12.15
6. Route the pneumatic supply pipe and electrical cable to the rear web
connections. Fit the loom and pipe to the appropriate connectors and
secure the electrical loom with a cable tie.
7. At the front web assembly, fully tighten the four chase rail securing bolts.
8. Connect the Screen Clamps - Off and Screen Clamps - On pneumatic
pipes to the quick release pneumatic connections shown below.
ADJUSTABLE SCREEN MOUNT (ASM)
REPLACEMENT PROCEDURES
12.16 Technical Reference Manual Chapter Issue 7 Oct 06
9. Thread the Rail Lock - Front pneumatic pipe through the slot in the chase
rail width scale assembly and connect the pipe to the front web assembly
pneumatic connection. Ensure the pipe is secured into the pipe clip.
10. Connect the rail lock pneumatic pipe to the push button valve on the web
bracket assembly.
11. Secure the web bracket assembly with the two securing screws.
12. Reconnect the electrical and pneumatic power to the machine and check for
air leaks.
13. Press and hold the relevant push button valve and ensure the front and rear
web assemblies release allowing the chase rail position to be adjusted.
Release the button valve and ensure the chase rail is now clamped in
position.
14. Power up the machine, in Diagnostics select Screen Change Module.
15. Select Toggle Screen Clamps and ensure the flap assemblies extend and
retract correctly.