00198596-02_JC_3M_C&P20P2M3_EN.pdf - 第21页
5 3-monthly C&P20 P2/M3 Clean / lubricate the Z-axis linear guide 6 min 5 / 5 Refer to safety instructions in user manual before commencing Maintenance NOTICE! ESD guidelines are to be followed Tool: T7, T21-T23, T47…
5 3-monthly C&P20 P2/M3 Clean / lubricate the Z-axis linear guide 6 min 4 / 5
Refer to safety instructions in user manual before commencing Maintenance
NOTICE! ESD guidelines are to be followed Tool:
T7, T21-T23, T47, T77, T96-T98
Wear Part: Consumables:
C10, C22
www.asm-smt.com
19 Dry clean the top of the z-axis from any re-
maining grease
20 Turn the head right side up and put the
headstand flat on the table.
21 Align the cover plate to the Z-axis and
tighten the 2 screws with a torque of 0.6
Nm.
22 Tighten the long screw at the side with a
torque of 1.30 Nm.
23 Tighten the short screw at the side with a
torque of 0.9 Nm.
24 Check the Z-axis is moving without touch-
ing the cover plate.
5 3-monthly C&P20 P2/M3 Clean / lubricate the Z-axis linear guide 6 min 5 / 5
Refer to safety instructions in user manual before commencing Maintenance
NOTICE! ESD guidelines are to be followed Tool:
T7, T21-T23, T47, T77, T96-T98
Wear Part: Consumables:
C10, C22
www.asm-smt.com
25 If not OK loosen the 4 screws and proceed
with step 20.
www.asm-smt.com