00198596-02_JC_3M_C&P20P2M3_EN.pdf - 第35页
8 3-monthly C&P20 P2/M3 Clean / lubricate the race way and clean the Z-axis jaw and light barrier 6 min 5 / 5 Refer to safety instructions in user manual before commencing Maintenance NOTICE! ESD guidelines are to be…
8 3-monthly C&P20 P2/M3 Clean / lubricate the race way and clean the Z-axis jaw and light barrier 6 min 4 / 5
Refer to safety instructions in user manual before commencing Maintenance
NOTICE! ESD guidelines are to be followed Tool:
T21, T22, T40, T41
Wear Part: Consumables:
C5, C15, C22
www.asm-smt.com
19 Move the star until a segment is in the Z-
axis jaw.
20 Move the Z-axis out of the head and move
the star carefully to the side until the bear-
ing is on the edge of the Z-axis jaw.
21 Clean the Z-axis jaw on both top and bot-
tom position using a slightly moistened
cleaning stick.
22 Clean the Z-axis light barrier using a
slightly moistened cleaning stick.
23 Move the star carefully back (1) until the
DP bearing is in the jaw again and move
in the Z-axis (2).
24 Remove the black rubber hose.
8 3-monthly C&P20 P2/M3 Clean / lubricate the race way and clean the Z-axis jaw and light barrier 6 min 5 / 5
Refer to safety instructions in user manual before commencing Maintenance
NOTICE! ESD guidelines are to be followed Tool:
T21, T22, T40, T41
Wear Part: Consumables:
C5, C15, C22
www.asm-smt.com
25 Clean up the multipette. See appendix
"Clean-up the multipette".
www.asm-smt.com