00195374-0202_AI_LBO-D1D2_DE+EN.pdf - 第55页
Long bo ard option 2 Assembly instructions Long board op tion SIPLACE D1 / D2 06/2007 Edition 55 2.8.2 Set-up : Select a set-up (see pictur e). : For the PCB conveyor , select "Long Board" and enter the value 1…
2 Assembly instructions Long board option SIPLACE D1 / D2 Long board option
06/2007 Edition
54
2.8 Changes in SIPLACE PRO
The option must be entered in the line configuration in SIPLACE PRO and in the set-up. 2
2.8.1 Line configuration
: Select the line and "Long Board" at the "Stations" check box.
Select "Long Board"
Select the line
2
2
2
2
2
2
2
Long board option 2 Assembly instructions Long board option SIPLACE D1 / D2
06/2007 Edition
55
2.8.2 Set-up
: Select a set-up (see picture).
: For the PCB conveyor, select "Long Board" and enter the value 150.000 under "Stopper 2 at
po
sition" for both processing areas.
Select the set-up
Enter 150.000
Select Long Board
150.000 150.000
2
2
2
The stopper position is not included in the optimization unless the "Use for optimization" box is
checked. 2
2
2
2
2
2 Assembly instructions Long board option SIPLACE D1 / D2 Long board option
06/2007 Edition
56
2.9 Function check
: Start the SITEST program.
: Check by adjusting the conveyor width whether the actua
tors reliably actuate the switches on
the units.
If this is not the case, readjust the affected actuators or units.
2
Teaching the sonar sensor 2
: Place a PCB on the conveyor.
: Push the PCB towards the processing area so that it is beneath the sensor.
: Hold down the button until the LED flashes (see photograph below).
Wh
en teach
ing mode starts, the LED lights up constantly while the PCB
remains in position.
Button
LED
2
2
: Remove the PCB from the conveyor and place it sideways across the conveyor side walls
above the sensor.
The LED must not light up; the LED must only light up if th
ere is a PCB on the conveyor.
2