4OM-1343-009_w.pdf - 第96页
1-40 AKFEMT -ID 0607-003 3.3.10 Conveyor Section Conveyor Belt Shafts (5 places) Every 3 Months Cleaning and Lubrication (MOL YNOC GREASE AP1) Required T ime: 5 minutes W ipe off the old grease with a rag and apply new o…
1-39
AKFEMT-ID
3.3.9 PCB Positioning Section
View A
View A
Upper Grease Nipple
Lower Grease Nipple
Upper
Nipple
Lower
Nipple
Upper
Nipple
Lower
Nipple
Upper
Nipple
Lower
Nipple
Upper Surface of Backup Table
Every Week Cleaning
Required Time: 2 minutes
Remove foreign substances and unrequired
components and suck dirt and dust with a
vacuum cleaner.
Ball Screws
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 10 minutes
Wipe off old grease with a rag and apply
new one with a syringe.
Take ample care not to leave any
waste threads after cleaning.
Grease should be applied every 3 months
after the initial month.
Use No. 19 (brown) nozzle.
Notice
Note
No. 19
Ball Screw Splines
(Grease Nipple 12 places)
Every 6 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 30 minutes
(1) Detach the tape guide.
Refer to "3.3.6 Cutter Section" for
the procedure.
(2) Wipe off old grease with an oiled rag.
Take ample care not to leave
any waste threads after
cleaning.
(3) Attach the U- and P-type attachments to
a hand grease gun and supply new
grease to the grease nipples with the
hand grease gun.
Notice
Reference
Type PType U
Fig. 4A30
0607-003
3.3 Inspection, Cleaning, and Lubrication Spots
1-40
AKFEMT-ID
0607-003
3.3.10 Conveyor Section
Conveyor Belt Shafts (5 places)
Every 3 Months Cleaning and Lubrication
(MOLYNOC GREASE AP1)
Required Time: 5 minutes
Wipe off the old grease with a rag and apply
new one with a brush.
Take ample care not to leave
any waste threads after cleaning.
Notice
Linear Guides (8 places)
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with a rag and apply
new one with a syringe.
Take ample care not to leave any
waste threads after cleaning.
Grease should be applied every 3 months
after the initial month.
Use No. 19 (brown) nozzle.
Notice
Note
No. 19
Fig. 4A31
3.3 Inspection, Cleaning, and Lubrication Spots
1-41
AKFEMT-ID
PCB Detection Sensors (14 places)
Every Week Cleaning
Required Time: 2 minutes
Clean the PCB detection sensors with a
rag.
Fig. 4A32
0607-003
3.3 Inspection, Cleaning, and Lubrication Spots