00900160-01_UM_ASM-ProcessLensDualLane_en.pdf - 第30页
2 Safety 2.4 Safety instructions for operating the machine 30 Instruction Guide ASM ProcessLens Dual-lane 06/2018 2.4 Safety instructions for operating the machine 2.4.1 Safety instructions for closing the protective cov…
2 Safety
2.3 Safety instructions for transporting the machine
Instruction Guide ASM ProcessLens Dual-lane 06/2018 29
2.3 Safety instructions for transporting the machine
Use a forklift truck with the following specification to carry the machine:
Fork length: min. 1800 mm
Carrying power: min. 6000 kg
Clear width between forks: min. 350 mm
WARNING
Risk of tipping
If the required specification cannot be applied to the forklift, there is a risk that the forklift
will tip over when carrying the machine.
Transportation of the machine is described in section 4.1 "Transport and delivery configura-
tion" [}55].
2 Safety
2.4 Safety instructions for operating the machine
30 Instruction Guide ASM ProcessLens Dual-lane 06/2018
2.4 Safety instructions for operating the machine
2.4.1 Safety instructions for closing the protective covers
CAUTION
Risk of crushing hands, if the protective covers are not closed correctly
To avoid risk of injury when closing the protective covers on the machine, the operator must
instruct the personnel
► Follow the instructions below when handling the protective covers.
Fig.24: Safety instructions for closing the protective cover
1 Recessed grip 2 Monitor
► To open or close the protective cover, always take hold of these by the recessed grip (1).
► When closing, do not reach into the gap between the protective cover and the machine panel.
► When closing the protective cover, make sure that the area in which it is swiveled is free of
obstruction and that no other people are at risk of injury.
► Pay attention to the monitor (2) and make sure it is not in the way of the closing door which
could result in irreversible damages.
2 Safety
2.4 Safety instructions for operating the machine
Instruction Guide ASM ProcessLens Dual-lane 06/2018 31
2.4.2 Insertion of board into the input and output conveyor
WARNING
Risk of injuries to hands when inserting a board into the input conveyor
When manually inserting the board into the input conveyor, hands could be caught by the
gantry and injured due to unprohibited access to the hazard area of the gantry.
The operating company is responsible for ensuring that the input and output conveyors are
covered to prevent anyone reaching into these areas with hands or arms.
All upstream and downstream modules (printer, placement machine, conveyors, etc.) must
take these same precautions.
2.4.3 ESD safety of machine
Please note chapter 2.8 "ESD Guidelines" [}42].