00193790-01.pdf - 第119页
Installation and Getting Started with CACCIA 2 English Issue 07/2004 2.10 O verview of the J umper Settings for Individual Subsystems 53 2.10.3.3 CAN Processor Board 16 Bit The 16 B it CAN Proces sor is us ed for differe…
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
52
2.10.3.2 Vision Board
The vision board is connected on the top of the head interface. That board is also used on the
gantry 1 with a C&P head.
Fig. 2 - 42 Vision board
Legend
(1) Connector illumination PCB camera
(2) Connector video signals PCB camera
(3) LED‘s P15V - 15Volt / Vcc - Power supply vision board
(4) DIP Switch
(5) CAN Processor 16 Bit (additional board on the vision board)
(6) DC/DC Converter 15 → 5V for visionsystem
4
5
1
3
2
6
Installation and Getting Started with CACCIA 2 English
Issue 07/2004 2.10 Overview of the Jumper Settings for Individual Subsystems
53
2.10.3.3 CAN Processor Board 16 Bit
The 16 Bit CAN Processor is used for different functions of the following units:
– Vision board, communication and control via the ICOS system
– Main board Twin head, control the vacuum generator
– Vision board for the stationary IC (FC) camera, communication and control via the ICOS
system
Fig. 2 - 43 16 Bit Processor
Description 7 Segment display (Standard mode "." flashed):
– After switch ON the machine "0" appears on the display
– Display "b" Bios is started.
– Display flash alternately "b" and "." → none Application available or can not started.
– Display "-I" und "I-" Application is loaded and now starts.
– The "." on the display flashed.
(1) 7 Segment display
(2) LED red at the manual RESET on
the Processors
(3) 16 Bit Processor
2
3
1
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
54
2.10.3.4 Head Adapter Twin Head
Theheadadapter board connects theheadinterface board directly to the mainboardof Twinhead
segment 1 and 2 via ribbon cable. This head adapter must be changed for head modularity, if you
use a C&P head.
Fig. 2 - 44 Head adapter Twin head
Legend
(1) Connector Z-Axis Twin head 1
(2) Connector D-Axis Twin head 1
(3) Connector DP-Axis Twin head 2
(4) Connector Z-Axis Twin head 2
(5) PP1 Boot CAN Processor Twin Segm. 1
(6) PP1 Reset CAN Processor Twin Segm. 1
(7) PP2 Boot CAN Processor Twin Segm. 2
(8) PP2 Reset CAN Processor Twin Segm. 2
1
24
3
OFF
1
4
5
6
7
8