00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第191页

9 Repairs to SmartFeeder 12 mm X / 16 mm X 9.5 Pickup window Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 191 ► Fix the pickup window into place using a screwed axle and 0.35Nm.  (1) Make sure that the head …

100%1 / 286
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.5 Pickup window
190 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Lift the pickup window up and off the tape duct.
9.5.2 Fitting the Pickup Window
► Fit the pickup window onto the tape duct from
above.
► Press the front of the pickup window down.(1)
► Push the pickup window sideways into the posi-
tion shown.(2)
Make sure that the pickup window engages in the
snap tab on the right-hand side of the tape
duct.(3)
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.5 Pickup window
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 191
► Fix the pickup window into place using a screwed
axle and 0.35Nm. (1)
Make sure that the head of the screwed axle is
flush with the side of the pickup window.
► Fasten the second screwed axle with 0.35Nm.
(2)
► Fit the compression springs into the feeder mod-
ule base unit as shown in the diagram. (1)
► Push the pressure fork from below against the
tape duct.(2)
► Fit the tape duct from above onto the feeder
module.(1)
Take care when doing this that, at the back, the
tape duct is flush with the ramp(2) and the splice
sensor (3). At the front, the pin in the pressure
fork must engage in the compression spring.(4)
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.5 Pickup window
192 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Stand the feeder module up.
► Hold the pickup window and tape duct with one
hand (as shown) to counteract the spring force of
the compression spring.
► Fasten the front screw of the tape duct with
0.6Nm(1).
► Fasten the back screw with 0.6Nm to the tape
duct.(2)
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Fasten the screw with 0.6Nm to the splice
sensor.(1)
► Fasten the top left screw with 0.6Nm to the side
cover(1).