00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第58页
6 Repairs to SmartFeeder 4 mm X 6.10 Tamp wheel 58 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 ► Screw the cover plate to the rocker. (4) Use a size T8 TORX screwdriver for this. 6.10 Tamp wheel Required spa…
6 Repairs to SmartFeeder 4 mm X
6.9 Rocker
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 57
Removing individual parts
To gain access to the individual spare parts of the
rocket foil disposal assembly, first remove the cover
plate.
► Remove the screw(1), fastening the cover plate..
Use a size T8 TORX screwdriver for this.
► Remove the cover plate.(2)
► Remove the bearing shaft.(3)
Use a size 1 flat-bladed screwdriver for this.
► Remove the tamp wheel.(4)
The spare parts in the rocker foil disposal assembly package can now be accessed and replaced
where necessary.
Fitting individual parts
► Insert the tamp wheel into the rocker, as shown
in the diagram.(1)
CAUTION!
When inserting the tamp wheel, make sure
that the plastic tab on the rocker is not bent
or broken off!
.
► Fasten the tamp wheel with the bearing shaft.(2)
Use a size 1 flat-bladed screwdriver to help you.
► Insert the cover plate as shown.(3)
6 Repairs to SmartFeeder 4 mm X
6.10 Tamp wheel
58 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Screw the cover plate to the rocker.(4)
Use a size T8 TORX screwdriver for this.
6.10 Tamp wheel
Required spare part
Fig.14: Knurled tamp wheel assy.
Feeder module Item no. Designation
SmartFeeder 4mm X 03131680-xx Knurled tamp wheel assy. X4Smart V2
Required tools
●
Phillips screwdriver, small
●
Flat-bladed screwdriver
●
Allen key size 4
●
Tweezers
6 Repairs to SmartFeeder 4 mm X
6.10 Tamp wheel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 59
6.10.1 Removing the tamp wheel
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see 6.3.1 "Removing
the Left Side Cover" [}31]).
► Remove the 3 Phillips screws(1) marked in the
diagram from the bearing cap for the foil drive.
► Lift the bearing cap(2) up with a pair of tweezers
or a small screwdriver(3) and remove it.
► Remove the rocker (see 6.9.1 "Removing the
rocker" [}54]).
► Remove the wiper (see 6.11.1 "Removing the
wiper 4 mm X" [}65]).
► Loosen the Allen screw on the spiral gear.
Use a size 4 Allen key for this.