00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第94页

7 Repairs to SmartFeeder 8 mm X 7.6 Splice sensor 94 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 7.6.1 Replacing the Dummy with a Splice Sensor ► Place the feeder module in a stable, upright posi- tion. The d…

7 Repairs to SmartFeeder 8 mm X

7.6 Splice sensor

Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 93

► Fasten the actuator axis with a fitting screw

Use a 1.5mm Allen key for this.

► Fasten the pickup window (see 7.5.2 "Fitting the

Pickup Window" [}90]).

7.6 Splice sensor

NOTICE

Removing retrofitted splice sensors

Each SmartFeeder 8mmX is prepared for using a splice sensor, although it is supplied

without the splice sensor. To re-establish this delivery state, you need to remove any retro-

fitted splice sensors before you send the feeder module back to the manufacturer for re-

pairs.

Required spare part

Splice sensor Dummy splice sensor

Feeder module Item no. Designation

SmartFeeder 8mm X 03107028 -xx Splice sensor X8Smart assy.

03104558 -xx Dummy splice sensor X8Smart

Required tools

●

TORX screwdriver 0.6Nm, size T8

7 Repairs to SmartFeeder 8 mm X

7.6 Splice sensor

94 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017

7.6.1 Replacing the Dummy with a Splice Sensor

► Place the feeder module in a stable, upright posi-

tion.

The dummy splice sensor(1) is located behind the

pickup window and is held by the "splice sensor filling

piece"(2).

► Loosen the TORX screw(3), with which the filling

piece(2) is fixed, until you can move the filling

piece.

► Move the filling piece in the direction of the arrow

until you reach the right-hand stop.

► Push the dummy splice sensor (1) next to the

filling piece until the two pins on the front of the

dummy is free.

► Pull the dummy up and out.

7 Repairs to SmartFeeder 8 mm X

7.6 Splice sensor

Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 95

► Insert the splice sensor(4) in place of the

dummy, as shown.

Make sure that the 2 fixture pins point forwards

and the 3 contact pins point backwards.

► Push the splice sensor(4) forwards, in the direc-

tion of the arrow, as far as the stop.

► Push the filling piece(2) in the direction of the ar-

row, towards the splice sensor, as far as the stop.

► Fix the filling piece with the TORX screw(3) and

0.6Nm.

The splice sensor is automatically contacted by the

board on the filling piece and is then recognized by the

software.