TM4642.TM4406.PickupMACS.pdf - 第3页

SMT Software Engineering Group IM Ope ration s Y A MAHA MOTOR CO ., L TD.  MDOC-SOFT50 177 3/ 23 1. T arget M odel Pick up MACS f unction c ons ists of two func tions [Fe eder MACS] and [No zzle MA CS]. The target m ode…

100%1 / 23
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
2/23
Revision No. Version Chapter No.
Revised Contents
00 V3.31STD R1.000 - -
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
3/23
1. Target Model
Pickup MACS function consists of two functions [Feeder MACS] and [Nozzle MACS].
The target model and version of Feeder MACS are as follows.
Table1.1 Target model and version (Feeder MACS)
Target Model Target Version Remarks
YS24 Series
YS24X Series
YS12 Series, YS100
YS88, YSH20, YSH2S
YC8
VGOS V3.31 STD R1.000 and later
Y.FacT V1.31 STD R1.000 and later
The target machine is
equipped SS feeder.
The target model and version of Nozzle MACS are as follows.
Table1.1 Target model and version (Nozzle MACS)
対象機種 Target Version Remarks
YS24 Series
YS24X Series
YS12 Series, YG12,
YS100
VGOS V3.31 STD R1.000 and later
Y.FacT V1.31 STD R1.000 and later
The machine equipped
FNC is un-supported.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50177
4/23
2. Summary
This function stabilizes pick up condition, mainly targeting small parts. It consists of the
following two functions.
- Feeder MACS
- Nozzle MACS
It is more effective to use these two functions together. However, it is possible to individually
select either one on [Machine Setting].
2.1. Feeder MACS
Feeder MACS detects a feeder set position, and corrects its pick up position without a manual
teaching.
A Feeder MACS correction value is cleared when the machine shut down or the feeder is
detached from the machine. In that case, Feeder MACS is executed again at the next pick up
action.
When the following buttons are pressed, Feeder MACS is always executed.
- The [Parts Adjust] - [Pickup] button
- The [Teach] - [Trace] button
When Feeder MACS is failed, pick up is executed without a Feeder MACS correction.
2.2. Nozzle MACS
Nozzle MACS detects a nozzle position, and calculates its appropriate pick up position.
The correction value is cleared when an operation concerning a nozzle change is executed,
such as loading board data, pick up error, or Emergency Stop etc.
You can specify whether or not to execute Nozzle MACS again after which operation.
Refer to [3. Setting].
When Nozzle MACS is failed, pick up is executed without a Nozzle MACS correction.