00195467-01_Installation Manual Setup Center 2.2.pdf - 第27页

Installation Manual SIPLACE Setup Center 2.2 5.2.3.3.2 Setting the CAN Bus Address You need to set a CAN Bus addre ss for each docking station. This CAN Bus address must be different for each docking station. 5  Set the…

SIPLACE Setup Center 2.2 Installation Manual

 Click on Finish to finish the installation.

5.2.3.3 Installing Docking Station

5.2.3.3.1 Safety Instructions

26 of 90

Installation Manual SIPLACE Setup Center 2.2

5.2.3.3.2 Setting the CAN Bus Address

You need to set a CAN Bus address for each docking station. This CAN Bus address must be

different for each docking station. 5

 Set the CAN Bus address for the docking station.

 Make sure that you only assign each address once, when setting the CAN Bus address,..

5.2.3.3.3 Establishing a Data Connection

Establish a data connection between the docking station and the SC PC. This data connection is

realized via a CAN Bus. You have already installed the CAN card in your PC, see Section

“Installing the CAN Card in the PC” on page

20. 5

Connect the CAN cable to the docking station and the PC. This CAN cable has 5 connections,

one of which you can use for the PC. This leaves 4 other connections, allowing you to connect up

to 4 docking station with this cable. 5

 Connect the CAN cable to the CAN connection at your docking station. This can be found

on the back of the docking station.

 Connect the CAN cable to the CAN card on the PC (CAN Bus 1 or 2).

27 of 90

SIPLACE Setup Center 2.2 Installation Manual

See the chapter

8.1 CAN Bus Cable Connection Examples for connection scenarios.

5.2.3.3.4 Compressed Air and Power Supplies

 Connect to the compressed air supply.

 Set the pressure reducer on the pneumatic connection (external) to 5.5 bar.

 Switch off the power supply and connect the CAN Bus cable to the device.

 Switch on the power supply.

28 of 90