00193161-01.pdf - 第51页
Manual S-20/S-23 HM/S-25 HM/F4/F5 HM /HS-50 Placement of 0402 components 03/2001 edition 51 5.3.2 Positioni ng the 0402 t ape sp acer (2 x 8 mm SII feeder) The positio n of the tape spacer depend s on which vers ion of t…
Placement of 0402 components Manual S-20/S-23 HM/S-25 HM/F4/F5 HM/HS-50
03/2001 edition
50
5.3 Using a tape support (spacer) with paper tapes
5.3.1 Spacer types
If 0402 components are fed in paper tapes, a tape spacer must be used at the pick-up position in
the feeder.
0402 spacer
for 8 mm SII feeders
Article number 00330832-01
(2 spacers are required for each feeder)
0402 spacer
for 3 x 8 mm S feeders
Article number 00349418-01
(3 spacers are required for each feeder)
Centering lugs for latching the spacer into position
in the pick-up or park position (see point ) in Fig.
5 - 2
, on page 46).
Feeders Article number Tape support Material
2 x 8 mm SII 00141096-xx 00330832-01 Aluminum
3 x 8 mm S 00141098-xx 00349418-01 Plastic
3 x 8 mm S for 0201/0402
components
00141099-xx No spacer required
A
P
Manual S-20/S-23 HM/S-25 HM/F4/F5 HM/HS-50 Placement of 0402 components
03/2001 edition
51
5.3.2 Positioning the 0402 tape spacer (2 x 8 mm SII feeder)
The position of the tape spacer depends on which version of the hold-down device is used. There
are one-sided or two-sided hold-down devices.
Fig. 5 - 6 Replacing the component cover, removing the foil removal beak
a &RPSRQHQWFRYHU
s 7ZRVLGHGKROGGRZQGHYLFH
Placement of 0402 components Manual S-20/S-23 HM/S-25 HM/F4/F5 HM/HS-50
03/2001 edition
52
5.3.3 Positioning the 0402 spacer on the two-sided hold-down device
Fig. 5 - 7 Positioning the 0402 spacer on the two-sided hold-down device
a VSDFHU
s &RPSRQHQWFRYHU
– Insert the 0402 spacer (item a in Fig. 5 - 7
) so that it is level with the component cover (item
s in Fig. 5 - 7
) in the tape channel of the feeder module.
– Position the 0402 spacer so that the notch in the center (item in Fig.
5 - 7
) is flush with the saw-toothed recess (item in Fig. 5 - 7) in the component cover.
A
B