OM-1455-004_w.pdf - 第54页

2-5 Tg1576-ID-SO 2.2.1 Pickup T ray Matrix When the [Pickup T ray Matrix] button is pressed in the "COMP . RELD." window , the "Pickup T ray Matrix" window appears. [2] [1] Fig. B3 "Pickup T ray …

2-4

Tg1576-ID-SO

When the feeder block button (F700) is pressed in the "COMP. RELD."

window, the operation sheet for component reloading on the single tray

feeder appears. The single tray feeder is installed on the selected feeder

block.

The "COMP. RELD." window for the single tray feeder is composed of the

"Pickup Tray Matrix" and "Tray Comp. Dt" operation sheets.

Note

When the feeder block button (where the single tray feeder is connected)

is pressed in the "PRODUCT." window, the "COMP. RELD." window for

the single tray feeder also opens.

Fig. B2-1 "COMP. RELD." Window

0708-002

2.2 Component Reloading

2-5

Tg1576-ID-SO

2.2.1 Pickup Tray Matrix

When the [Pickup Tray Matrix] button is pressed in the "COMP. RELD."

window, the "Pickup Tray Matrix" window appears.

[2] [1]

Fig. B3 "Pickup Tray Matrix" Window

[1] Component Reload Buttons

When the component-reloaded step is selected and the [Set] button is

pressed, the tray pickup matrix of the selected step is set to "(1, 1)" and

the number of remaining components is updated.

Reloaded Step Selection :

The component-reloaded step must be

selected.

[Set] Button :

When pressed, this button sets the

component reloading condition with the

specied value.

Note

As for the steps that are not used in the pattern program, no component reload

button is displayed.

[2] Step Selection Buttons

When a magazine and a step are selected, the "Block Information"

window appears, making it possible to check and change the tray

matrices.

0708-002

2.2 Component Reloading

2-6

Tg1576-ID-SO

[3]

[4]

Fig. B4 "Block Information" Window

[3] "Block Information" Sheet

Shown is the block information.

[4] Tray Pickup Matrix Setting Buttons

Shown is the tray pickup matrix data.

When the [Edit] button is pressed, an input window opens, making it

possible to set the tray pickup matrix data.

Note

As for the blocks that are not used in the pattern program, no tray pickup

matrix setting button is displayed.

[5] [Return] and [Set] Buttons

[Set] Button :

When pressed, this button sets the edited tray

pickup matrix data and opens the tray pickup

matrix editing window

[Return] Button :

When pressed, this button cancels the selection

of the tray pickup matrix data and opens the tray

pickup matrix editing window.

0707-001

2.2 Component Reloading