OM-1455-004_w.pdf - 第71页

3-6 Tg1576-ID-SO (C01) Feeder Bases #1, #2, #3, #4, and Work Area Fig. C5 "Feeder Base #3" Edit Window It can be determined which components must be used and which feeder base (Fdr No.) must be loaded with the …

100%1 / 97
3-5
Tg1576-ID-SO
2. Pattern Program
2.1 Description of Pattern Program
2.1.1 Placement Feeder Location Data
The "Tray" and "Tray Step" tabs in each "Feeder Base #" tab can be used to
set the placement feeder location data for the single tray feeder.
Note
In this Instruction Manual, the condition example is described where the
single
tray feeder has been attached to the feeder base No. 3.
Front Side of Machine
Rear Side of Machine
Feeder Base #1
Feeder Base #2
Feeder Base #3
(Single Tray Feeder)
Feeder Base #4
Fig. C4
0711-003
2. Pattern Program
3-6
Tg1576-ID-SO
(C01) Feeder Bases #1, #2, #3, #4, and Work Area
Fig. C5 "Feeder Base #3" Edit Window
It can be determined which components must be used and which feeder
base (Fdr No.) must be loaded with the selected components.
The tape feeders can be installed on the feeder bases.
Front Side of Machine
Rear Side of Machine
Feeder Base #1
101 to 150 301 to 350
201 to 250 401 to 450
Feeder Base #2
Feeder Base #3
Feeder Base #4
Fig. C6 Positional Relation between Feeder Bases
Work Area
The work area is the place where the data is stored temporarily.
This area is something like a virtual feeder base in which the data can
be stored temporarily and can be used to temporarily keep the data
overowing after data conversion, pattern program creation, etc.
0711-003
2.1 Description of Pattern Program
3-7
Tg1576-ID-SO
(C01_01) Fdr No.
Shown are the feeder Nos. in the placement feeder location data.
The numbers in ( ) indicate the feeder Nos. that will actually be loaded
with components.
Feeder Base #1 :
101 to 150
Feeder Base #2 :
201 to 250
Feeder Base #3 :
301 to 350
Feeder Base #4 :
401 to 450
Work Area :
001 to 099
103 313
213 403
Front Side of Machine
Rear Side of Machine
Feeder Base #1
Feeder Base #2
Feeder Base #3
Feeder Base #4
Fig. C7
(C01_02) Component ID
Set component IDs in the text boxes.
0711-002
2.1 Description of Pattern Program