OM-1455-004_w.pdf - 第80页

3-15 Tg1576-ID-SO 4. System Setting 4.1 Of fset Data 4.1.1 Unit Offset When the "Unit Ofst" subtab is pressed in the "Device Offset" tab sheet and the "T ray" subtab is further pressed, the …

100%1 / 97
3-14
Tg1576-ID-SO
3. Component Library
3.1 Carrier Data
This is a tab sheet which corresponds to all component shapes -
"Cylindrical", "Square", "Deform", "IC (Simple)", "IC (Complex)",
"Connector (Simple)", "Connector (Complex)", "Other Leaded (Simple)",
"Other Leaded (Complex)", and "BGA/CSP".
When the "Carrier Data" tab is pressed, the "Carrier Data" tab sheet appears.
Fig. C12 "Carrier Data" Tab Sheet (Type: Tray Selected)
Note
Refer to "2.3 (A03) Carrier Data" in "Chapter 2" of the instruction manual
"Component Library" for details of each data.
Set "Tray" in the "Type" text box of the label "Carrier data" and enter
parameters in the other text boxes of the label "Carrier data" and in the text
boxes of the label "Tray data".
0711-002
3. Component Library
3-15
Tg1576-ID-SO
4. System Setting
4.1 Offset Data
4.1.1 Unit Offset
When the "Unit Ofst" subtab is pressed in the "Device Offset" tab sheet and
the "Tray" subtab is further pressed, the following subtab sheet appears.
Fig. C13 "Tray" Subtab Sheet
Note
The displayed subtab sheet will look different, depending on which option
is selected.
(1) Traverse
This offset is used to adjust the pallet drawing position.
X [mm] (Horizontal)
The set parameter is added to the beam travel when components are
picked up.
Y [mm] (Vertical)
The set parameter is added to the beam travel when components are
picked up.
(2) Traverse chute level
L [mm] (Height)
This offset data is used to adjust the level (height) of the pallet drawing
chute.
When a level lower than the design height is set, a plus value must be
entered in the text box.
0711-001
4. System Setting
3-16
Tg1576-ID-SO
4.2 Auto Operation
4.2.1 Tray matrix update setup
When the "Tray Matrix Update Setup" subtab is pressed in the "Auto
Operation" tab sheet, the following subtab sheet appears.
Fig. C14 "Tray Matrix Update Setup" Subtab Sheet
(1) Tray matrix update setup
Select "X Direction" or "Y Direction" (direction in which components
should be taken out) in the text box.
In normal cases, "Y Direction" should be selected.
X
Y
Y
Selection of "Y Direction"
Selection of "X Direction"
X
Fig. C15
0711-001
4.2 Auto Operation