6241f.pdf - 第12页
Page 4 GS-394-02 Machine System Software IM-Universal Platform Software (IM-UPS), and an OS/2 WARP operating system, are standard. This graphical user interface provides a number of capabilities, including: System Setup …
Page 3GS-394-02
Network Kit
Standard with each machine is a package for computer network
connection capability that includes an Ethernet network card and
IBM OS/2 TCP/IP client software. This provides high speed,
reliable communications and data transfer to all computers con-
nected to the network.
Board Error Correction (BEC)
Board Error Correction allows the positioning system to compensate
for lead hole location variations between printed circuit board lots.
A light source and sensor are used to sense the variation and make
these corrections.
Operator
Board Error Correction Detection Area
Due to the position of the Board Error Correction sensor relative to
the insertion point, there is an area which cannot be scanned by the
sensor. The non-scannable area is at the rear of the positioning
system regardless of rotary table rotation.
This area cannot be scanned by
Board Error Correction Sensor.
22.86mm
(0.900")
470mm
(18.5")
508mm (20.0")
Dimensions are in millimeters;
inch equivalents are bracketed.
+Y
Insertion
Centerline
BEC Sensor
Offset
+X
22.86mm
(0.900")
Page 4 GS-394-02
Machine System Software
IM-Universal Platform Software (IM-UPS), and an OS/2 WARP
operating system, are standard. This graphical user interface provides
a number of capabilities, including:
System Setup
• Machine Configuration — User configuration of machine op-
tions, such as board handling and tooling.
• Event Configuration — Configuration of events for display and
control of machine status light.
• Security may be configured based on user/function.
Advanced Product Editor (APE)
• Graphical Program Generation and Editing — Component
location can be programmed/edited in either text or graphical
format. Graphically displays all component insertions relative
to PC board.
• Import of CAD Data for Program Generation (see following
section).
Product Changeover
• Load Product — User selection of previously stored product
programs.
Production Control
• Counts — Allows setting inserter counts.
• Manual Control — Manually controls (zero, move) all axes of
the machine.
Product Changeover Icon
Production Control Icon
APE Icon
System Setup Icon
Graphical User
Interface
Page 5GS-394-02
Machine Status Icon
Management Information Icon
IM Diagnostics Icon
On-Line Documentation Icon
Machine Status
• Current Messages — Displays current controller messages and
events.
Product Status — Displays status of running product.
• Analytic Information:
• Discrete I/O — Ability to read each input and set each
output individually.
• Message History — Ability to view message log.
• Operations — Sets machine modes: Step, Single Cycle, Insert,
Pattern.
• Error Recovery — Recovery processes for operational errors,
i.e., mis-insertion.
Management Information
• Timers — Collection and display of machine timers.
• Counters — Count of machine events: insertions, insert errors,
boards, Bad Board Reject, Board Error Correction, circuits.
• Component Data — Counts by component ID: placements,
errors.
From these databases, a variety of reports can be created.
IM Diagnostics
• IM Diagnostics — Ability to exercise machine sub-systems on
an individual or combined basis outside of machine control
software.
• B.E.C. Set-Up/Analysis.
• Machine Set-Up Support.
On-Line Documentation
• IM-UPS documentation is available on-line.