Maintenance Schedule保养计划.pdf - 第40页
Vision XP+ V AC / XP+ / XP / XS Page 49 2 Mainte nance 2.14 C onveyor S ystem Service Instructions V ersion 1.3 2.14 C onv eyor Syste m 2.14.1 Chain Lubricator – Checkin g and Refilling the T ank Fig. 2-82 Chain lu brica…
Page 48 Vision XP+ VAC / XP+ / XP / XS
2 Maintenance
2.13 Residual Oxygen Meter
Service Instructions
Version 1.3
Detail drawing of the activated carbon filter on the adapter plate.
1. Cover activated carbon filter
2. Tube activated carbon filter
3. Woven filter medium
4. Plug-in connection QS – 1/8-6
5. O-Ring 12 x 4 mm
6. Adapter activated carbon filter
Fig. 2-80 Exchange activated carbon
Fig. 2-81 Exchange activated carbon
Now, exchange each one non-wo-
ven insertions on both sides of the
activated carbon filter with the twee-
zers.
Exchange activated carbon and
densify it.
Now, mount everything in reversed
order.
6
3
2
5
1
4
Vision XP+ VAC / XP+ / XP / XS Page 49
2 Maintenance
2.14 Conveyor System
Service Instructions
Version 1.3
2.14 Conveyor System
2.14.1 Chain Lubricator – Checking and Refilling the Tank
Fig. 2-82 Chain lubricating pumps with two
and one outlet
The chain lubricator is located on
the operator side behind the second
door on the right.
There are two chain lubricating
pumps in the VXP system, each
with one or two outlets.
Consumable materials, tools:
• Chain fluid
Procedure:
1. Fill to a level of about 1 cm
below the brim.
2. Inspect to make sure that the
hose connectors are securely
attached to the lubricator units.
Caution!
The chain lubricator should not be
allowed to run completely empty,
because if the pump runs dry
damage may result.
Page 50 Vision XP+ VAC / XP+ / XP / XS
2 Maintenance
2.14 Conveyor System
Service Instructions
Version 1.3
2.14.2 Chain Lubricator – Replacing the Felt Wheels
Fig. 2-83 Chain – Felt Wheels
Consumable materials, tools:
• Chain fluid
• Felt wheels Center Board
Support / PCB´s
Procedure:
1. The felt wheels should be lightly
saturated with oil, and should
make contact with the conveyor
chain.
2. If no chain oil is present,
double-check the chain
lubricator settings at the
controller. Start the chain
lubricator manually and check
to see if oil is delivered to the
lubricator unit.
3. The felt wheels must be
replaced or readjusted if they
no longer make contact with the
conveyor chain, or if they are
frayed.
4. Inspect, and if necessary
replace the felt wheels for the
lubricator unit at the fixed side
panel.
5. Inspect, and if necessary
replace the felt wheels for the
lubricator unit at the other side
panels.