TS577R-UserGuide.pdf - 第18页

18 Note: If the sequence mode is set to activate memory cell 1 – 3, and the delay time is set at 5000 ms, the controller will activate memory 1 to 3 cont in uously with 5000 ms delay between each activation. 5.6 Cycle Co…

3. Enter number of memories to be run in sequence (ex. 1 to 3)

4. Touch the “Sequence Mode” icon

5. Touch the Check Mark icon to save and exit

The screen will look similarly to the screen below:

Notes:

A. If there is no delay time entered in the setting, the operator has

to press the foot switch or touch the Run icon after each

memory cell is completed to activate the next memory cell.

B. If delay time is entered in the setting, the controller will activate

the next memory cell in sequence automatically.

5.5.3 To run in Continuous Sequence Mode

1. Follow step 1 to 2 above then enter the waiting time “delay time” between

each activation.

2. Touch the “Sequence Mode” icon

3. Touch the “Continuous Mode” icon

4. Touch the Check Mark icon to save

5. Touch the X icon to exit

The screen will look similarly to the screen below:

Note: If the sequence mode is set to activate memory cell 1 – 3, and the

delay time is set at 5000 ms, the controller will activate memory 1 to 3

continuously with 5000 ms delay between each activation.

5.6 Cycle Counter

The cycle counter records the numbers of automatic dispense cycle being

activated. Up to 999,999 cycles can be recorded. To reset the counter, follow

steps below:

1. Touch the Setup icon to enter setup screen

2. Touch the Counter Reset icon to reset counter

3. Touch the Check Mark icon to confirm

4. Touch the X icon to exit

5.7 Over Current Protection

This controller is equipped with the over current protection for motor. If the

motor current is over 400 mA, the “Over Current Detected” message will apprear

on the screen and the unit will be disabled.

When this issue happened, check the valve to for clogging. Clean the valve

thoroughtly if necessary.

If after the valve has been cleaned and the over current is still occurred, then it is

time to replace the motor.

Touch the X icon to clear the over current message and reset the unit.

5.8 To Change Password

Note: The default password is “0000”. To change password, follow the

instructions below.

1. Touch the Login icon to enter the login screen

2. Touch the change “Password” icon