00196622-03_OM_WPC5_6_EN.pdf - 第36页
Setting up and Commissioning Adjusting the WPC Height from 900mm to 930mm 4.2.4 Undocking t he WPC5/WPC6 36 Operating Manual SIPLACE WPC5/WPC6 ► Completely remove all four counter screws with an SW 17 (1) because th e …
Setting up and Commissioning
4.2.4 Undocking the WPC5/WPC6 Adjusting the WPC Height from 900mm to 930mm
Operating Manual SIPLACE WPC5/WPC6 35
Removing the WPC5/WPC6
► Open the machine covers on the relevant changeover table.
► Move the changeover table out of the machine.
► Fasten the hexagonal shaft (crank handle) to the lifting mechanism of the WPC and turn in a clock-
wise direction, to lift the WPC5/WPC6.
► Stop turning as soon as you have enough room to undock the WPC5/WPC6 from the machine. Make
sure that the feeder mechanism does not get caught anywhere!
► Remove the WPC5/WPC6.
Transportation of the WPC5
► When the lifting axis is in its lowermost position (transport position), the WPC5/WPC6 can be moved
on a level floor.
► To transport on the hand lift, ALWAYS turn the carriage COMPLETELY up. If you do not, the weight
of the WPC will burden the lifting spindle of the carriage and the spindle could be bent.
4.3
4.3 Adjusting the WPC Height from 900mm to 930mm
Adjusting the WPC Height from 900 mm to 930 mm
► Remove the cover to get access to the four settings
screws (1) and the four counter screws (2).
▪ Adjust the counter screws with an SW 17.
▪ Adjust the setting screws with an SW 24.
Setting up and Commissioning
Adjusting the WPC Height from 900mm to 930mm 4.2.4 Undocking the WPC5/WPC6
36 Operating Manual SIPLACE WPC5/WPC6
► Completely remove all four counter screws with an
SW 17 (1) because the WPC needs to be lifted from
900 mm to 930 mm.
► Remove the counter screws accordingly when lower-
ing the WPC.
⇨ After the counter screws have been removed, you
can lift the WPC by screwing the setting screws in.
► Evenly lift the WPC from 900 mm to 930 mm by
screwing in the settings screws with an SW 24 (1).
► Make sure to adjust all four of them evenly.
Setting up and Commissioning
4.2.4 Undocking the WPC5/WPC6 Adjusting the WPC Height from 900mm to 930mm
Operating Manual SIPLACE WPC5/WPC6 37
► Screw the settings screws out until the WPC lies on the blocks.
► Through the machine base, screw the four counter screws into the upper part.
▪ For 900 mm height, the distance is 20 mm.
▪ For 930 mm height, the distance must be 50 mm.
The adjustment to 930 mm can be simplified by using
four spacer blocks (each one 50 mm in height) (1).
► Insert the four spacer blocks. Make sure that there is
enough play around the blocks to remove them later
on.
NOTICE
Setting screw
Make sure not to screw out the setting screw too far; it must also lie on the block.