00196622-03_OM_WPC5_6_EN.pdf - 第37页
Setting up and Commissioning 4.2.4 Undocking the WPC5/WPC6 Adjusting the WPC Height from 900 mm to 930mm Operating Manual SIPLACE WPC5/WPC 6 37 ► Screw the settings sc rews out un til the WPC lies on the block s. ► Thr…
Setting up and Commissioning
Adjusting the WPC Height from 900mm to 930mm 4.2.4 Undocking the WPC5/WPC6
36 Operating Manual SIPLACE WPC5/WPC6
► Completely remove all four counter screws with an
SW 17 (1) because the WPC needs to be lifted from
900 mm to 930 mm.
► Remove the counter screws accordingly when lower-
ing the WPC.
⇨ After the counter screws have been removed, you
can lift the WPC by screwing the setting screws in.
► Evenly lift the WPC from 900 mm to 930 mm by
screwing in the settings screws with an SW 24 (1).
► Make sure to adjust all four of them evenly.
Setting up and Commissioning
4.2.4 Undocking the WPC5/WPC6 Adjusting the WPC Height from 900mm to 930mm
Operating Manual SIPLACE WPC5/WPC6 37
► Screw the settings screws out until the WPC lies on the blocks.
► Through the machine base, screw the four counter screws into the upper part.
▪ For 900 mm height, the distance is 20 mm.
▪ For 930 mm height, the distance must be 50 mm.
The adjustment to 930 mm can be simplified by using
four spacer blocks (each one 50 mm in height) (1).
► Insert the four spacer blocks. Make sure that there is
enough play around the blocks to remove them later
on.
NOTICE
Setting screw
Make sure not to screw out the setting screw too far; it must also lie on the block.
Setting up and Commissioning
Adjusting the WPC Height from 900mm to 930mm 4.2.4 Undocking the WPC5/WPC6
38 Operating Manual SIPLACE WPC5/WPC6