M6ex_ServiceManual_e.pdf - 第11页

1 Installation 1-3 How to Hoist the Machine Use the wires and the arm as follows. NOTE: Be sure to use the arm to preven t the wire from touching the machine. Front View Arm Wire Side View Arm Wire

1 Installation

1-2

Installation of Machine

Environmental Requirements

Install the machine at the place where the below conditions are met.

Do not do tasks, such as moving the machine or connecting the machine with the main switch ON to

prevent electric shock.

■ Ambient Temperature: Accuracy assurance 23 +/-2 degrees centigrade

Operation assurance 5 to 40 degrees centigrade

(The average over a period of 24 hours does not exceed 35 degrees C.)

■ Relative Humidity: 45 to 60 percent, non-condensing

■ Altitude: 1,000 or below above sea level

■ Atmosphere: Dust and corrosive gas free

■ Floor: Floor must be flat and sturdy enough for freedom from vibration during

operation.

■ Power Requirements: 200 VAC +/- 10%, three phase, 50/60 Hz

* 208/220/230/240/380/400/415/440V VAC with optional power

transformer

Power consumption: 0.77KW

Installed capacity: 2.01kVA

Leakage current: 20mA or less

* Power and ground the machine independently of other machines which may be a

noise source, such as a compressor, welding machine, or reflow soldering machine

with magnetic contacts.

Warning

1 Installation

1-3

How to Hoist the Machine

Use the wires and the arm as follows.

NOTE: Be sure to use the arm to prevent the wire from touching the machine.

Front View

Arm

Wire

Side View

Arm

Wire

1 Installation

1-4

■ Recommended Bolt Size

● Type 1 (M20 x P2.5)

● Type 2 (M20 x P2.5)

MxP D d d1 L2 L3 S T L R H B C

Type1 Type2

20ｘ 2.5

25 48 62 20 28 37 32 16 90 98 2 12 17 19.8

[Unit = mm]