M6ex_ServiceManual_e.pdf - 第18页

1 Installation 1-10 Supplementary Explanation for Installation When setting up a production line, level adjustment a nd line positioning of the machine m ay be carried out at the same time. However, to fine-adjust the ma…

1 Installation

1-9

Intake-side air coupler

65SN/85SN (Nitto Kohki) or equivalent

Air coupler

ir regulato

0.5MPa

1 Installation

1-10

Supplementary Explanation for Installation

When setting up a production line, level adjustment and line positioning of the machine may be carried out

at the same time. However, to fine-adjust the machine position with the machine level, i-PULSE

recommends that the machine be roughly positioned to the production line first, and then be leveled and

positioned accurately using the following four sets comprising a hydraulic jack and plates.

ACTION:

① Apply grease between base plates 1 and 2 for lubrication purposes.

② Place a plate set near each machine jack-up point (four points).

③ Place a jack on each plate set and jack up the machine.

④ Adjust each jack so that the machine is level.

⑤ Fine-adjust the position of the machine while the machine is jacked up. (The machine can be moved

lengthwise and crosswise with help of grease applied between the plates.)

Hydraulic jack

Base plate 1

Base plate 2

Apply grease

between the

lates.

Hook stroke

1 Installation

1-11

NOTE: The machine cover must be removed while jacking up the machine

NOTE: The hydraulic jacks must satisfy the following requirements.

Allowable load: 1.5 tons or higher

Hook size: 100mm or more (stroke)

Part Name

Part No. Remark

PLATE,BASE LG0-M8911-00X For plates 1 and 2

Jack-up point

Four points.(two each at

front and rear) Remove the

cover at jacking up.

250 (500) 250