M6ex_ServiceManual_e.pdf - 第69页

4 Electrical Section 4-3 ■ Details tab Action: ① Select Tool>StartScan to display each sensor status. ② Select Tool>EndScan to end. ■ FIO tab ■ Feeder tab “1” indicates that the feeder has been set. “0” indicates t…

4 Electrical Section

4-2

Signal I/O

Signal I/O is the abbreviation of signal input/output. The signal input refers to the input signal via the

sensors. The signal output refers to the command transmitted to the actuators.

Signal Output (Control) window serves as controls to move actuators for checking their movements. In

response to their movements, Signal Input (Monitor) window shows On/Off of motors and actuators.

Note: The Signal Input and Signal Out put windows are opened at the same time. You can move actuators using

the Signal Output window while simultaneously checking the signal input status in the Signal Input

window.

Signal Input Monitor

You can check On/Off of the sensors real-time. “1” indicates on, “0” off. When a sensor of a switch, motor,

and actuator responds, the change of the sensor status is shown real-time. Wire disconnection or sensor

failure can also be detected.

Menu: Manual>Signal I/O>Signal Input (Monitor)

These menus allow you to check each sensor status real-time. You can specify the sampling cycle for the

status check.

■ List tab

■ Changing the Sampling Cycle

Action:

① Select Option>SampingCycle.

② Enter sampling cycle (ms) larger than the minimum of 300, and click <OK> button.

③ Select Tool>StartScan to start checking.

④ Select Tool>EndScan to end.

Note: Use the minimum sampling cycle (300) normally.

Note: The combination of an address and bit number (0-7) represents a signal. The name of each signal is shown

in the Details tab.

4 Electrical Section

4-3

■ Details tab

Action:

① Select Tool>StartScan to display each sensor status.

② Select Tool>EndScan to end.

■ FIO tab

■ Feeder tab

“1” indicates that the feeder has been set.

“0” indicates that the feeder has not been set yet.

4 Electrical Section

4-4

■ Motor tab

■ Motor Sensor tab

Window:

ALM: Alarm

MEL: Minus End Limited

PEL: Plus End Limited

MARK: Mark

INP: In Position

MSLD: Minus Slow Down

PSLD: Plus Slow Down

EZ: 0 Phase

ORG: Origin