PC150-Manual-REV-A-2.pdf - 第14页
PC150 Valve Manual Revision A / Jan uary 202 2 Page 14 of 26 Figure 13 : Fully Disassembled Fluid Section Clean the Disassembled Va lve Clean ever y wetted par t complet ely with a co mpatibl e solvent, lint - free t owe…
PC150 Valve Manual
Revision A / January 2022
Page 13 of 26
Figure 10: Remove the Fluid Section Screws
10. Pull the wetted section from the upper air cylinder.
Figure 11: Remove the Wetted Section
11. Separate the lower fluid blocks.
Figure 12: Separate the Lower Fluid Blocks
12. Make sure the fluid section is fully dissembled.
PC150 Valve Manual
Revision A / January 2022
Page 14 of 26
Figure 13: Fully Disassembled Fluid Section
Clean the Disassembled Valve
Clean every wetted part completely with a compatible solvent, lint-free towels, and cotton
tipped applicators to clean the valve wetted section. This includes the ends of the rods. Do
not mix material A and B or the material may cure. Wear protective gloves. Do not get
material or solvent on your skin.
Make sure all grease and material are removed from the valve components before the valve
is assembled again. All O-rings, seals, and screws should be cleaned and replaced if
damaged.
PC150 Valve Manual
Revision A / January 2022
Page 15 of 26
Assemble the Valve
This section shows how to assemble the PC150 series valve.
1. Install two (2) VLV-011K O-rings in the top of manifold.
Figure 14: O-rings in the Manifold
2. Install two (2) VLV-006K O-rings in the top side of seal plate.
Figure 15: O-rings in the Seal Plate
3. Install two (2) VLV-001K O-rings in the bottom side of the fluid body.
Figure 16: O-rings in the Bottom of the Fluid Body