192866 Issue 4 - Reel to Reel Manual LoRes.pdf - 第23页

TECHNICAL REFERENCE REPLACEMENT PROCEDURES Chapter Issue 1, Apr 15 Reel to Reel Manual 1.13 REPLACEMENT PROCE DURES T ransport Carriage Belt s T o replace one of the transport carriage b elts, use the following procedure…

100%1 / 40
TECHNICAL REFERENCE
ADJUSTMENTS AND SETTINGS
1.12 Reel to Reel Manual Chapter Issue 1, Apr 15
Inner Transport
Vacuum Plate
Home Position
The home position is a datum for the software to use as a start point and is not
a critical position. The home vane should be fixed centrally to the two fixing
screws that secure it.
TECHNICAL REFERENCE
REPLACEMENT PROCEDURES
Chapter Issue 1, Apr 15 Reel to Reel Manual 1.13
REPLACEMENT PROCEDURES
Transport Carriage
Belts
To replace one of the transport carriage belts, use the following procedure:
1. Remove the product reel from the machine.
2. Using a 3mm Allen key, loosen the four belt clamp securing screws (two on
the right hand side of the inner transport vacuum plate and two on the left
hand side).
3. Remove the transport belt, taking note how the belt is fitted in the clamp.
NOTE
If the transport carriage belt is broken, remove any debris from the machine.
TECHNICAL REFERENCE
REPLACEMENT PROCEDURES
1.14 Reel to Reel Manual Chapter Issue 1, Apr 15
4. Fit one end of the new belt in the belt clamp on the right hand side of the
inner transport vacuum plate ensuring the correct amount of belt is protrud-
ing out of the bottom of the clamp, see table below:
5. Tighten the belt clamp.
6. Feed the belt over the top of the belt pulley on the right hand side of the
transport mechanism.
7. Continue to feed the belt under the inner transport vacuum plate and feed
the belt over the left pulley.
8. Fit the end of the belt in the belt clamp on the left hand side of the inner
transport vacuum plate ensuring the correct amount of belt is protruding out
of the bottom of the clamp, see table below:
9. Tighten the belt clamp.
10. Check the other two belts for damage.
Belt Position Dimension
Front Belt 25mm below the clamp
Middle Belt 20mm below the clamp
Rear Belt 15mm below the clamp
Belt Position Dimension
Front Belt 25mm below the clamp
Middle Belt 20mm below the clamp
Rear Belt 15mm below the clamp