4OM-1610-002_w.pdf - 第101页
4OM-1610 1-50 4. Maintenance Method : Chap.1 Ultrasonic Cleaning Method • Set the nozzle onto the nozzle cleaning jig as shown in the following gure and dip it in the ultrasonic cleaner lled with water , together with …
4OM-1610
1-49
4. Maintenance Method : Chap.1
Cleaning Method
Procedure
(1) Store the nozzle in the nozzle stocker (housing) through window
navigations and take out the nozzle stocker (housing).
Notice
Do not take out a nozzle from the head by hand. Otherwise, the
nozzle does not conform to the nozzle data.
Reference
Refer to "5. Nozzle Change Window" in "Chapter 6 (Vol. 2)" for the
procedure of nozzle storage.
(2) Blow air to remove dust and dirt.
At this time, use clean, dry, and non-lubricated air.
Clean the tapered area of the nozzle with a lens cleaning cloth.
When the tapered area is extremely dirty, brush the nozzle end 20 to 30 times
with a toothbrush and then clean the nozzle in the water with an ultrasonic
cleaner.
When a recognition error occurs frequently, rub the back of the collar
approximately 20 times with a toothbrush.
Notice
(a) Do not blow air to the nozzle being attached to the head.
Doingotherwisemaycausetheltertopopoutofthehead.
Theltermaydamagethehead.
(b) Do not use anything other than water for the cleaning.
When the ultrasonic cleaning operation is to be performed
underwater,
removethenozzlelter.
Note
Demagnetize the vacuum nozzle after the detachment.
Keep the head section free of any magnetic eld.
As an example,
•
Do not bring a magnet close to the head section.
•
Do not bring any demagnetizer to the head section.
1011-001
4OM-1610
1-50
4. Maintenance Method : Chap.1
Ultrasonic Cleaning Method
•
Set the nozzle onto the nozzle cleaning jig as shown in the following gure and
dip it in the ultrasonic cleaner lled with water, together with the jig.
Then, clean it for about 15 minutes.
Note
The nozzle cleaning jig must be prepared on the customer side.
•
After washing with the ultrasonic cleaner, blow air to the nozzles.
When the nozzles are not dry enough, wipe them with a rag.
Notice
When a nozzle is set in the jig, pay attention to the orientation of the
nozzle.
F3.5 (THRU)
(159)
12
12
12
12
12
12
12
12
12
12
12
13.5
15
10
15
15
(65)
10
15
13.5
10
Material: Duracon (POM)
Nozzle Cleaning Jig (Example) F4A39-2
1011-001
4OM-1610
1-51
4. Maintenance Method : Chap.1
4.2 Nozzle Filter Change
4.2.1 Nozzle Filter Removal Procedure
Push out the nozzle lter using the lter removal jig as shown in the following
gure.
Filter Removing Jig
Vacuum Nozzle
Push
Pushing out the nozzle filter.
F4A39-3
1011-001