4OM-1064-001.pdf - 第22页

Tg0249-PM-MM 5. Weekly Maintenance 0004-002 1-12 Component Pick-Up Position of T ape Feeder Cleaning Remove adhering dirt, etc., with a brush whenever necessary . Fig. 1.14 Component Supply Section (Feeder) Beam A Side B…

100%1 / 274
Tg0249-PM-MM
5. Weekly Maintenance
9910-001 1-11
Fig. 1.13 PCB Positioning Section
Upper Surface of Fiducial Mark
Cleaning
Remove dirt and dust using a rag.
Component Discharge Box
Abandonment
Remove the components accumu-
lated in the box.
Protective Glass of the Compo-
nent Recognition Camera
Cleaning
Drop dirt and dust into the compo-
nent discharge box using the air blow
for the camera. If the protective glass
is dirty with grease, remove it using
a rag.
Fig. 1.12 Component Recognition Section
Beam A Side
Beam B Side
Beam A Side
Beam B Side
PCB Positioning Section
Cleaning
Clean dirt and dust on the upper sur-
face of the PCB backup table using a
vacuum cleaner.
Tg0249-PM-MM
5. Weekly Maintenance
0004-002 1-12
Component Pick-Up Position of
Tape Feeder
Cleaning
Remove adhering dirt, etc., with a
brush whenever necessary.
Fig. 1.14 Component Supply Section (Feeder)
Beam A Side
Beam B Side
Table 1.6
6. Monthly Maintenance
Note: Grease Symbols
DE1 : DAPHNE EPONEX GREASE No.1
NM1 : NEW MOLYNOC GREASE No.1
9910-001 Tg0249-PM-MM1-13
6. Monthly Maintenance
Maintenance Spots Check
Name
Fig.
No.
Description Grease
Cleaning
Tools,
Nozzles, etc.
Teaching Plate
Section
Teaching Plate
(Component
Recognition Offset
Jig), Position of
Teaching Plate, Back
Light Stage
1.15 Checking and Cleaning  Air Blow for
Camera
Nozzle Stocker Cam Follower 1.16 Cleaning and
Lubrication
 Oiled Rag,
NM1, Brush
Nozzle Storage
Section
1.16 Cleaning  Rag
Inside of Vacuum
Nozzle
1.17 Cleaning  Air Gun
Hole of Vacuum
Nozzle
1.17 Cleaning  Air Gun
Vacuum Nozzle End 1.17 Cleaning  Rag
Placement Head Vacuum Filter 1.18 Checking  Vacuum
Filter,
Replacement
Jig