4OM-1064-001.pdf - 第27页
T able 1.7 7. Maintenance (Every 3 Months after Initial Maintenance in 1 Month) CAUTION The ball screws and linear guides have a high mainte- nance priority . The initial maintenance should be performed in one month. Aft…
Fig. 1.18 Placement Head
Vacuum Filter
Checking
Remove the vacuum filter with the
vacuum filter replacement jig (at-
tached) and check for dirt.
Replace the filter with a new one
when it is stained excessively.
Refer to “2.2 Replacement Procedure
of Vacuum Filter” for details.
Beam A Side
Beam B Side
6. Monthly Maintenance
9910-001 Tg0249-PM-MM
1-16
Table 1.7
7. Maintenance (Every 3 Months after Initial
Maintenance in 1 Month)
CAUTION
The ball screws and linear guides have a high mainte-
nance priority.
The initial maintenance should be performed in one
month. After that, it should be performed every three
months.
Notes: (a) Perform break-in after lubrication. After a proper break-in, wipe off
any dropped grease with an oiled rag.
(b) Grease Symbols
DE1 : DAPHNE EPONEX GREASE No.1
NM1 : NEW MOLYNOC GREASE No.1
7. Maintenance (Every 3 Months after Initial Maintenance in 1 Month)
0004-002 Tg0249-PM-MM1-17
Maintenance Spots Check
Name
Fig.
No.
Description Grease
Cleaning
Tools,
Nozzles, etc.
Feeder Base Cam and Cam Follower 1.19 Lubrication
NM1
Brush or
Cloth
X-Axis Ball Screw
(2 nipples)
1.20
-1
Cleaning and
Lubrication
DE1
Oiled rag,
Hand or Brush
X-Axis Linear Guide
(8 nipples)
1.20
-2
Cleaning and
Lubrication
DE1
Oiled rag,
H Type
Y-Axis Ball Screw 1.21 Cleaning and
Lubrication
DE1
Oiled rag,
Hand or Brush
X/Y Beam
(Beams A and B)
Y-Axis Linear Guide
(8 nipples)
1.21 Cleaning and
Lubrication
DE1
SPK-3C,
U and P
Types,
Oiled rag
Placement Head Ball Screw and Nut
(4 nipples)
Linear Guide
1.22 Cleaning and
Lubrication DE1
U and
N Types,
Oiled rag
Large Linear Guide
(2 nipples)
1.23 Cleaning and
Lubrication
DE1
Oiled rag, N
and U Types
Small Linear Guide 1.23 Cleaning and
Lubrication
DE1
Oiled rag,
Hand or Brush
Clamp Sections of
Tray Traverse
Cam Follower 1.23 Cleaning and
Lubrication
DE1
Oiled rag,
Hand or Brush
1-180004-002 Tg0249-PM-MM
A
Beam A Side
Beam B Side
A
Fig. 1.19 Feeder Base
Cam and Cam Follower
Lubrication (NM1)
(1) Remove the plate on the side of
the feeder base as shown in the
figure.
(2) Apply new grease with a brush, etc.
The cam and cam follower are lo-
cated in the depth of Arrow A.
Note: Lubricate it covering this
section with cloth, etc. to
avoid dropping grease
onto the wiring.
7. Maintenance (Every 3 Months after Initial Maintenance in 1 Month)