GL541保养手册.pdf - 第29页

Installation 1. Remove any hardened glue on the end of the adapter or flange surface of the needle. Note: The internal diameter is marked on the needle for identification, as shown in the following figure. 2. First, moun…

4. Remove the needle from the adapter.

Note: Use the jig shown below to remove needles which are stuck to the syringe by dried

glue.

1. Holder

2. Retainer

3. Plate

4. Nut

JRG-0700

HRG-1260

JRG-0690

HRG-1271

Jig

Jig Jig

Jig

GL541-m77E

Needle

Adaptor

Chapter 3 Changeover

Version 3.6 3-3-2 GL-541E Maintenance

Installation

1. Remove any hardened glue on the end of the adapter or flange surface of the

needle.

Note: The internal diameter is marked on the needle for identification, as shown in the

following figure.

2. First, mount the adaptor and needle on the syringe, then mount the syringe,

adaptor, and needle assembly on the head's syringe holder.

Note: The mounting orientations of the syringe holder and adaptor, and the adaptor and

needle, are determined by the locating pin and the notch. When setting the needle

in the adaptor and tightening the cap nut, be sure that the adaptor pin is securely

positioned in the needle's notch.

Storage of the Needles

1. Soak nozzles that have been removed in one of the solvents listed below and then

store. To reuse the needle, clean off the solvent and any residual glue using

compressed air.

Solvents: Acetone or trichlene.

“Safety Cleaner 41 g” manufactured by Loctite.

“Cleaner S-10” manufactured by Sanei Chemical Co.

Note: For details, refer to the catalogs of glue manufacturers.

Notch

Locating pin

Needle

Adaptor

Cap nut

Syringe

holder

GL541-m79E

Indicates 0.5 mm inner diameter.

GL541-m38E

Chapter 3 Changeover

Version 3.6 3-3-3 GL-541E Maintenance

Blank Page

Chapter 3 Changeover

Version 3.6 3-3-4 GL-541E Maintenance