GL541保养手册.pdf - 第30页
Blank Page Chapter 3 Changeover V ersion 3.6 3-3-4 GL-541E Maintenance
Installation
1. Remove any hardened glue on the end of the adapter or flange surface of the
needle.
Note: The internal diameter is marked on the needle for identification, as shown in the
following figure.
2. First, mount the adaptor and needle on the syringe, then mount the syringe,
adaptor, and needle assembly on the head's syringe holder.
Note: The mounting orientations of the syringe holder and adaptor, and the adaptor and
needle, are determined by the locating pin and the notch. When setting the needle
in the adaptor and tightening the cap nut, be sure that the adaptor pin is securely
positioned in the needle's notch.
Storage of the Needles
1. Soak nozzles that have been removed in one of the solvents listed below and then
store. To reuse the needle, clean off the solvent and any residual glue using
compressed air.
Solvents: Acetone or trichlene.
“Safety Cleaner 41 g” manufactured by Loctite.
“Cleaner S-10” manufactured by Sanei Chemical Co.
Note: For details, refer to the catalogs of glue manufacturers.
Notch
Locating pin
Needle
Needle
Adaptor
Adaptor
Cap nut
Syringe
holder
GL541-m79E
5
Indicates 0.5 mm inner diameter.
GL541-m38E
Chapter 3 Changeover
Version 3.6 3-3-3 GL-541E Maintenance
Blank Page
Chapter 3 Changeover
Version 3.6 3-3-4 GL-541E Maintenance
GL-541E Maintenance Manual
Version 1.0 December 15, 1995
Version 2.0 March 30, 1996
Version 3.0 November 1997
Version 3.1 September 25, 1998
Version 3.2 February 16, 1999
Version 3.3 March 10, 1999
Version 3.4 August 26, 1999
Version 3.5 May 10, 2000
Version 3.6 September 28, 2001
FUJI Machine Manufacturing Co., Ltd.
SMT Equipment
19 Chausuyama, Yamamachi, Chiryu,
Aichi Prefecture, 472-8686 Japan
Copyright 2001 by Fuji Machine Manufacturing Co., Ltd.
Printed in Japan
The FUJI Internet
Fuji Internet aims at providing information to our customers in
the most efficient manner. This site makes a range of services
available, from manual updates and FAQs, to online technical
reports. Fuji hopes that this site will be used as a source of
information in addition to the services provided by your agent.
Fuji’s website is located at http://www.fuji.co.jp/
Fuji Internet membership is required to access the Technical
Information section of the site, contact your agent for details.
Any comments or opinions regarding this manual can be sent to
intnetqst@fuji.co.jp