SA_MAES4S_en.pdf - 第16页

16 4 T est and Change Device Parts 4.10.1 Check the Sensors via Control Panel Gelb Pantone 123C , Grün RAL 6018 , Blau Pantone 7461 , Grau Pantone 422C , Beschriftung, Fenster- und LED-Umrandung Schwarz, Fenster- und LED…

100%1 / 24
15
4.9 Changing the Energy Track
Danger!
Danger to life and limb from power supply.
Befor open the device unlink the power!
5
7
6
8
4
3
2
1
Fig.14 Energy track mount / dismount
1. Dismount the rear cover. Page 13
2. Loosen screws (2) and remove PCB cover (1) .
3. Pull connector (3 and 4) and put out the cable from the cable retainer on the power supply (7) .
4. Loosen screws (4) and (8) .
5. Remove the energy track (7) .
Mounting the energy track (7) in reverse order.
4.10 Check the Sensors
Some sensors are integrated into the Maestro 4S to control the function and operation of the device.
Thisarereexsensorswithaswitchreactionincaseasurfaceareinfrontofapprox.3mmdistance.
For changing and adjusting is a 5,5 mm jaw wrench necessary.
3mm
Fig.15 Reexsensor
4 Test and Change Device Parts
16
4 Test and Change Device Parts
4.10.1 Check the Sensors via Control Panel
Fig.16 Control Panel
Switch of the machine.
Ungear the carriage.
Press the button combination to choice the test mode and switch on the machine.
Move the carriage to switch on/off the sensors.
To leave the test mode switch of the machine.
i
Notice!
You can test the sensors on the carriage only withh a mounted front cover.
Sensor Button combination to choice the
test mode
Display
clock sensor
Press button (home) and
(plus) at once time.
Display speed switched between and
side sensor left
Press button (home) and
(speed) at once time.
Display mileage switched to
side sensor right
Press button (home) and
(speed) at once time.
Display mileage switched to
carriage sensor left
Press button (home) and
(speed) at once time.
Display mileage switched to
carriage sensor right
Press button (home) and
(speed) at once time.
Display mileage switched to
Table 2 Check the Sensors via Control Panel
17
4 Test and Change Device Parts
4.10.2 Check the Sensors on PCB
Some sensors are integrated into the Maestro 4S to control the function and operation of the device.
Thisarereexsensorswithaswitchreactionincaseasurfaceareinfrontofapprox.3mmdistance.
For changing and adjusting is a 5,5 mm jaw wrench necessary.
3mm
Fig.17 Reexsensor
To check the function of a sensor are checkpoints on the PCB integrated.
5
21
43
GND
Fig.18 Checkpoints to check the sensor function
Nr. Bezeichnung Sensor
1
SSR 2
carriage sensor right
2
TS
pulse sensor
3
RR
side sensor right
4
SSL 2
carriage sensor left
5
RL
side sensor left
GND
Ground
Table 3 Sensor - short description
4 1 32 5
Fig.19 Sensor position