Apollo1_Operators_Manuel.pdf - 第60页
60 cab - Produkttechnik GmbH / Tharo Systems, Inc. Printer Info The "Printer info" parameter provides information about the firmware. Furthermore, information about the cumulative length of printed media as wel…
59cab - Produkttechnik GmbH / Tharo Systems, Inc.
Heat Level
The parameter "Heat level" enables the printer to adapt to possible differences
in the thermal properties of different printheads.
The parameter scale is from -9 to +9.
A previous adjustment has already been carried out in the factory.
In the event of replacing the printhead, the setting possibly has to be adjusted.
To adjust the printer to current print jobs, it is recommended that you alter the heat
level parameter via software. (e.g. for different material and speed)
You may also change this value using the software commands. Any front panel
value and software command value are totaled together for printing.
The current field to be changed is flashing in the display.
Fig. 9 i Set "Heat level" parameter
Heat level
+ x
Heat level
- x
Heat level
± 9
Heat level
± 0
*
*
*
Heat level
± x Yes
Heat level
± x No
Confirmation
Sign (+ or -)
8 Heat level
9 Printer info
Heat level
7 Printhead pos.
F
60 cab - Produkttechnik GmbH / Tharo Systems, Inc.
Printer Info
The "Printer info" parameter provides information about the firmware.
Furthermore, information about the cumulative length of printed media as well
as the number of operating hours are shown.
8 Heat level
9 Printer info
10 Set date
Printer info
Printer info
Version xxxxxxx
Printer info
xxxxxx m/ xxxx h
Fig. 9 k Printer info display
61cab - Produkttechnik GmbH / Tharo Systems, Inc.
Set Date
The "Set date" parameter allows you to change the system date of the Apollo.
The date format shown depends on the selected "Country" parameter.
Regardless of the format, the order of data to be changed (day - month - year)
always follows the same routine as shown below. (Figure 9 l)
The date range available is from January 1, 1970, to December 31, 2069.
If an invalid date entry is made, the display shows "Invalid input!"
After pressing the key the parameter may be set again.
Date changes in the software will only influence the date on the printout but not
affect the system date as stored in the setup.
The current field to be changed is flashing in the display.
10 Set date
11 Set time
Day
Month
Year
Confirmation
*
*
*
*
*
*
Set date
xx.12.xxxx
Set date
xx.01.xxxx
Set date
xx.xx.2069
Set date
xx.xx.1970
Set date
31.xx.xxxx
Set date
01.xx.xxxx
Set date
xx.xx.xxxx Yes
Set date
xx.xx.xxxx No
*
*
*
Fig. 9 l Set system date
9 Printer info