00194313-03.pdf - 第68页

2 Assembly Instructions for PCB Camera, Multicolor SIPLACE S-25 HM / S-27 HM 2.2 Installing PCB Camera Board and PC B Camera Multicolor 02/2007 Edition 68 2.2 Inst alling PCB Camera Board and PCB Camera Multicolor At S-2…

SIPLACE S-25 HM / S-27 HM 2 Assembly Instructions for PCB Camera, Multicolor

02/2007 Edition 2.5 Preparatory Steps

Fig. 2.14 - 2 Terminal block on the right-hand side

No additional wiring is required. The connections are prewired. 2

2 Assembly Instructions for PCB Camera, Multicolor SIPLACE S-25 HM / S-27 HM

2.2 Installing PCB Camera Board and PCB Camera Multicolor 02/2007 Edition

2.2 Installing PCB Camera Board and PCB Camera

Multicolor

At S-25 HM possibly the modular head PCB assembly is not installed yet. 2

Abb. 2.2.1 Conversion PCB "small axis" still installed (= old PCB version)

: If the conversion PCB "small axis" is still installed on the placement head, assembly the mo-

dular head PCB unit now on the basis of its own assembly instructions (see chapter "Require-

ments").

At S-27 HM the modular head PCB assembly is always installed. 2

CAUTION

Comply the ESD regulations during the following handling of the PCBs.

Make certain that no screws or other parts drop into the machine or the placement head !! 2

SIPLACE S-25 HM / S-27 HM 2 Assembly Instructions for PCB Camera, Multicolor

02/2007 Edition 2.2 Installing PCB Camera Board and PCB Camera Multicolor

2.2.1 Removing PCB Camera (Normal Illumination) incl. Oblique Illumination

Execute the following steps at each gantry.

Abb. 2.2.2 Loosening Cable Ties, Removing Subgantry PCB Camera (Using HS-50 as an Example)

*) Cable routing for S-25 HM: see Abb. 2.6.9.

: Remove the cover over the placement heads (undo 5 screws on each).

: Undo the flat cables above the placement head.

: Undo the cable ties along the cable harness.

: In case of initial situation "old PCB camera with head PCB moduar": On the "Vision board, mo-

dular" unplug the connectors of the subgantry PCB camera (normal illumination) and - if pre-

sent - the oblique illumination.

1 Cover of feeder modules: to be removed

2 U-shaped rail for cable guide *)

3 4 unit, cable ties

4 Subgantry PCB camera (with normal illumination) to be removed)

5 Fasteners for the PCB camera: 3 socket hex head cap screws M3 x 10