88181945-01-06 Technical Reference Manual ( Production Iss 06 December 2020).pdf - 第11页
11 Issue 06 , December 2020 T empe rature Sensor loom WARNING Temperature Input Signal Voltage = 0 – 10Vdc. Under no circumstances must voltages exceeding 10Vdc be applied to the input connection. FIG 6 Connect the Tempe…
10 Issue 06, December 2020
Indicator Beacon
Remove the indicator beacon from its protective packaging. Pass the beacon loom
connector through the plenum base into the electrical compartment (FIG 3) and secure
the beacon with the supplied fasteners (FIG 4).
FIG 3 FIG 4
Connect the beacon loom to the Control PCB connector CN2.
CN2
FIG 5
WARNING
ELECTRICAL HAZARD. Ensure Isolator is in the OFF
position before opening access door.
WARNING
BEWARE OF MOVING PARTS. Allow time for fan rotation to
cease before opening access door.
11 Issue 06, December 2020
Temperature Sensor loom
WARNING
Temperature Input Signal Voltage = 0 – 10Vdc.
Under no circumstances must voltages exceeding 10Vdc be
applied to the input connection.
FIG 6
Connect the Temperature Sensor Loom between the TCM and the Printer Service Plate
FIG 7 FIG 8
12
Issue 06, December 2020
Conditioned Air Outlet
Printer Air Return
Air Ducting Hose
Connect Air Ducting Hoses to the TCM using the supplied hose clips. The upper port is
the conditioned air outlet. The lower port is for air returning from the Printer.
FIG 9
Connect TCM Conditioned Air Outlet ducting to the Printer Air Inlet duct using the
photographs below for reference.
Air Duct A – Outer and Inner
Air Duct B – Outer and Inner