Sonic Buzzer S F C - Serie.pdf - 第22页
2 Retrofit instructions SOKO Sonic Buzzer SIPLACE S / F / C-series SOKO 04/2006 Edition 22 2.3 Safety instructions W ARNING The safety instructio ns from the “Operational sa fety” chapter of the user ma nual and servicin…
SOKO 2 Retrofit instructions SOKO Sonic Buzzer SIPLACE S / F / C-series
04/2006 Edition
21
2 Retrofit instructions
SOKO Sonic Buzzer
SIPLACE S / F / C-series
2.1 Functionality / Features
– When the SIPLACE encounters pick-up error and the SIPLACE do not stop, tower light flashes
and buzzer is off.
– When the SIPLACE stops due to malfunctions, tower light are permanently on and buzzer
sounds.
– When the SIPLACE encounters pick-up error and machine stops, tower light is permanently
on and buzzer sounds.
– To reset the sonic buzzer press any stop button on the machine or solve the problem.
The buzzer will sound only when the white tower light is over 3 seconds. The frequency is 0.5 se-
conds. 2
To adjust the loudness turns the knob on the speaker box. 2
2.2 Requirements
SIPLACE S / F / C-series 2
Retrofit package of SOKO Sonic Buzzer S/F/C-series (00176016-02) 2
2
2
2 Retrofit instructions SOKO Sonic Buzzer SIPLACE S / F / C-series SOKO
04/2006 Edition
22
2.3 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.3.1 Definition
2
Please note 2
2
2
2
SOKO 2 Retrofit instructions SOKO Sonic Buzzer SIPLACE S / F / C-series
04/2006 Edition
23
2.4 Scope of delivery
Retrofit package of SOKO Sonic Buzzer S/F/C-series (00176016-02) consists of the following: 2
– Control unit partial preinstalled
– 2-core cable
– Sonic buzzer with knob
– Retrofit instructions of Sonic Buzzer S/F/C-series (00195061-xx)
2.5 Necessary tools
– Set of hexagonal
– Set of screw drivers
– Edge cutter
– Permanent marker.
2
2